NW WA Meet / BS Thread

Nooooooo

 

I don’t think so.

 

It's a word. I use it quite often as an adjective. It really helps describe things.

 

Lol, just had to go drive through Seattle and stop at Dicks. I knew I should have stopped listening to the wife after she started the death march down to the bottom of the falls.

 

Oh shit, you guys took the trail to the power house at the bottom? I bet that was a good burn when you made it back to the lookout, and then realized you parked in the upper UPPER lot.

You know there's a parking lot to use at the bottom to access the power house right?

 

I mentioned that when we walked by it. She says yeah I don’t remember it being this far

 

Are you the person/member getting these from ECGS?

 

Heading up there tomorrow! Hope there is still snow!!

 

Yes, they had Randy’s build this one after 2 of the ECGS built ones failed. Randy’s said they built it the same as a Randy’s diff. All new berings caps R&P the whole 9 yards. Good to go and should be bulletproof. They have all seen mostly blacktop and some logging roads. I haven’t taken it wheeling since I went to 4.88’s. If I was beating the hell out of it it would make sense. This is diff #3 not 4 kinda lost track in my rage.

 

Weee back on the road again and thanks to Covid I get to ride from Everett to Concrete on the back of a rollback in my truck

 

Rain up to 10k feet, might be a hair left although it will be shitty

 

Hello all, I’m thinking about switching to 12” kings in the rear and am wondering if anyone local (I’m in auburn will travel within reason) has any experience welding and installing bamf or archive shock relocation kits. Thanks for reading.

 

Hello again, are there other shops or places to get gears aside from ecgs,and just differentials? Been saving up for a bit and will hopefully be ready by March. Just looking for other ideas/options.
Thanks.

 

I can do that! Im up in Carnation, so not too far.

Just did some 14''ers up into the bed on mine not long ago with some Ruffstuff brackets. But both the bamf and archive kits are top notch

 

Pm’ed

 

Does anyone have the Needle Bearing puller/install tools?

 

Back

 

If nobody else can get ya one, ill mail you mine

 

mail? Oh snap you moved!

 

Yup! Year and a half ago!