What Have You Done To Your 3rd Gen Today?

This is the place we got them from. You can customize the crap out of them
https://hozzify.com/?s=Tacoma+&post_type=product

 

Check them out. You can customize them
https://hozzify.com/?s=Tacoma+&post_type=product

 

Built water storage today. Wanted the weight low and forward. Works well as I can house pressure fill the bottom and vent the air at the top. Going to add a pressure gauge and schrader valve to the top spigot. That way I can use my compressor if/when I need more pressure. For now the 50-60 psi out of the tap works to pressurize the tank. Ordered 10 ft of braided 1/4 line and a shower head for showers if needed

 

I dig it!

 

Follow up- today I worked on the switch side of the harness. Actually it was 3 harnesses to be exact. (Side note: whenever I have a mod that intersects with another I try to do them together to limit the removal of certain parts (not if it’s a simple 1 panel step). This is why it can take up to a yr before I complete a project unfortunately between being side tracked or planning it all out.) So my seat heater switches I wanted in the overhead, I also wanted my front camera switch up top and to relocate my vsc switch from the top to below the climate control. With the limited space in the a pillar I left a void in the sheathing I used on the harnesses in order to combine all into a wrap around style sheath (this way I can add more wires for a forth switch). Now that the harness is ran I need to focus on painting the new switch panel/inserts to complete this 3 mod project.

Was able to squeeze and tuck the harness in the pillar no problem. it’s barely visible, follows factory/away from airbag and no panel bulges when completed.

 

KDmax-Pro tune.......

 

Or a paper clip

 

I run a hardware store. I’ve got those. I just haven’t tried it yet. Thanks I will probably do that. Wish me luck

 

How much water does it hold?

 

So, added my rear 5100 and a 1 inch block. Also my spc arms got my caster to 3.2/3.5 in the front. Added 1/4 inch shims to my front that is set at 1.1. Total measured lift is around 1.8 inches in the front now. With 1.25 inch spacers

 

I would guess about 5.8 gallons

 

Assuming that's 4" pipe and the total length (including elbows) is 9.5' it should be close to 6.2 gallons.

To determine the capacity of a cylindrical tank

Area of tank head = diameter squared X .7854

Multiply answer by length to get cubic content

Convert cubic content to gallons (one gallon= 231 cubic inches)

Be careful to use all numbers in either inches or feet (DO NOT MIX UNITS)

 

I was thinking 4inch by 9 feet

 

Hey JohnB81, where does that separate module get installed (the one with the antenna) behind the dash also?

 

Threw on a Leer 100XR and waiting for the Prinsu racks

 

The rack will dress it out nicely.

 

What have I done?!?!? Behold the monstrosity that is... "The Christmas Taco."



Edit: I bought and installed the only cap I could find in the area...had to drive 2 hours for it even.

 

She'll be easy to find at the mall.

 

Thanks so much! They’re from Unique Style Racing. I was on the notification list for Meso and found these in the meantime, so I jumped on it!