Let's see your FJ case swap

Bare wire properly braided put in place, drop of glue and zip tie to secure the wires to the harness did the trick, I have shaken the hell out of them and still works every time. Cheers.

 

TCase is in, anybody has issues getting the add to activate one last time? I couldn’t get it to change for shit now I just have blinking lights and 2lo

 

Is the tcase actuator plugged in? If I recall correctly the ECU looks for a signal from the tcase actuator to engage the front shaft before it will flip the ADD actuator.

 

I have both Plugs in the case. I just need to jump start the ADD to think it’s in 4wd so I can leave it

 

I tried with no luck to get 4wd before pulling the case

 

how is the noise inside the cab with this setup? looks good btw!

 

Noticeably more road noise but not as loud at MT tires. I also added killmat while I had access. LOL

 

pin 1 and 2 will need to apply 12v and ground respectively to lock. Use a small motorcycle battery or even a 9volt will work.

 

@6 gearT444E can your help me install in the spring?

 

yes but due to inflation costs have risen.

 

I charge a 6 pack for friends that need vehicle work but this year I've upped it to an 8.3 pack. Times are tough

 

Ah, the elusive 8.3 pack. Solid choice.

 

Which color is pin 1&2?

 

the pins are not colored they all look the same.

 

I think he meant in your pic so he has some sort of reference.

 

oh, yeah that makes sense haha. It will be the red and white wires. If you’re not sure take an ohmmeter and measure through them to get the motor resistance. You should read around 4-6 ohms.

 

Does anyone have a transfer case out of the 6 spd FJ cruiser (AWD Torsen VF4B) that they want to get rid of?

 

PM sent.

 

Replied! Thank you sir

 

the case on the right is what I’m looking for, for reference. It’s an inch longer than the case found in the auto trans FJs and has a 22 spline male input shaft


And here’s the end goal for anyone curious. I’ve done the AWD conversion once now in my 6spd, now im looking to do the same in my 5spd