Wiring MESO 3rd Brake Light

What gauge wire do you recommend for running the amber lights all the way up to the front of the cab to switch? And what gauge wire for the jumpers for the brake light?

 

How is the black finish holding up on those bolts?

 

unfortunately I haven’t gotten around to installing the 3rd brake light yet.

 

Same, been laggin hard.

 

I just used 18 TXL everywhere but it’s probably overkill for everything.

That listing has a bunch of different lengths. Which one did you use?

 

M3 x 6mm, black

 

Can anyone tell me what gauge wire that Toyota is using for the third brake light?

 

I hope they do because I just bought the kc5 housing and 5 V2s. @MESO will this housing work with the new V2s cyclones?

 

I just tried looks like the new V2s will work but I have to use the KC black rubber piece that hides the screw. Also going to need slightly smaller washers. Everything else should be good. I would just have to pay extra attention with the RTV silicone in the open areas as the diameter isn’t as smooth as the v1 @MESO

 

Looks like the V2s will work. Will give an update when it’s finally installed. Did a dry fit today. All looks well @MESO

 

Do you have the reds hooked up to your hazards? Gonna install my KC5 soon

 

If you screw out the bolts will the nuts fall off on the other side?

 

Negative wired in series with a brake light flasher module off Amazon