Installing dual 10s in my 05

It says to lift rear seat slightly. How do I do this.

Fits behind the rear seat, remove plastic panel-tray from back wall. Sit cabinet in place, raise the back of the seat slightly, cabinet will drop into place.

https://vi.raptor.ebaydesc.com/ws/e...714080000&ver=0&cspheader=1&oversion=7d958d56

thanks

 

Lift the seat back like you’re going to close it, it will drop into place.

 

i just got the truck so im not familiar with that how do i do that?

 

like put the seat back down then lift it back up and it will drop down in to place?

 

Go poke around. You'll figure it out. The seat backs fold down, and the seat itself opens up. Hinged at the front.

 

so once the back is down the seat folds forward?

 

If you have the Owner's Manual, you will probably find details and pictograms about how to operate the seats.

Just a thought...........

 

Thanks guys

 

honestly easiest way is to remove the back seats, just takes 7 bolts and the back seat comes out. 6 bracket bolts and one seatbelt bolt

 

Where did you ground your amp? My kits coming tomorrow and want to do the install.

are those comp 10 subs? How do they sound?

 

I had the amp back there on the box. The ground was in between the seat bracket and the chassis, I sanded the area to get good contact. Those are the comp s 10 from a few years ago, they were meant for a 1 cubic ft box and that box is only .8 cubic ft. They have good high bass but not low low bass, I ended up putting polyfill in there to trick the subs to think it was a bigger enclosure was gave me some low bass back but not much. Also heads up you might need to brace the box the middle part between the 2 subs tend to reverb. I just got 2 inch L brackets from Home Depot and it was enough to take the noise away

 

Thanks for the info. I got the new comp 10s on their way. I never had 10” before I’m used to a 15” in a ported box in my old Jeep Patriot. I know it won’t be the same but anything will be better than the stock system.

 

No problem, just a heads up check the seal on the box. I had a couple air leaks from where the caulk was cracked and I just re-caulked it

 

Ok I will. My box is rhino coated. I hope this helps the reverb and air leaks.

 

I took out the back panels this morning. Is that middle seat bolt good for the ground?

 

just sand down where you are ground to have less resisitanceand a good connection, I went to that middle bracket in that pic. the front bolt inbetween the bracket and the body of the truck

 

I just ran all my wires. When’s ups gunna get here jeeze

 

Says out for delivery

 

Finished the install. Pretty good sounding. Messy wires but here’s a pic.

 

What’s the break in time on comp s10’s?