Eibach pro lift kit

Recently bought and received eibach pro truck lift stage 2 with toytec AAL, JBA UCA and purchased summit off road wheels (wheel eta is 2 plus months) but need to install everything, no time or space to install atm.

 

Honestly no clue, I didn’t measure before or after lol.
Set on the first notch
Running 285/70/17’s
Wheels are 17x8.5 -12 offset

 

Looks great either way. Did you have to do the CMC with that lift/tire setup?

 

We’ll have to see…. Shop said they didn’t need to. I’m assuming they maxed the caster on my UCA’s and was all good. But for off-roading…. I’m assuming I’ll need it done. No clue though I’ve driven it for maybe 5 miles

 

Update…def will need a CMC. This is the wheel at full lock

 

@Morningbeers oh wow, thats close for sure!

 

Gotta pay to play lol

 

Has anyone ran the Eibach stage 2 with a new Icon RXT leaf pack on option 1? I'm ordering a ORDCSB and trying to configure a lift that suits my needs. Box will only have occasional heavy loads. Looking for a lift that will be functional, firm up the soft OR handling and look ok with 265/75/16's. Looking at this from a buy once standpoint.

 

Just installed my stage 2 yesterday, not too bad but still need to do add a leaf, I got toytec add a leaf.

 

I’m getting this exact setup put on next week so I’ll let you know how it goes once it’s on

 

I have over 1000 miles on my Eibach lift (Stage 1). Currently set the 2nd perch (middle) with stock UCA's. The rears I have the Icon AAL's with the overload spring installed. Rides a bit stiff that stock but not too bad for my taste. Also, fabricated a brake line guide as well.

 

How necessary is the brake line mod? Did you do 2” in the rear? That’s a great looking lift/tire set up!

 

Thanks, I appreciate it.

Its a 2" lift for the rears, but I opted to leave the overload spring in against ICON instructions. The netted a 2.5 inch lift. Most other lifts have you to leave it in too. no issue so far. Just make sure the shims are set in the right direction.

From what I read on the forums, some ppl let the brake lines hang. I haven't heard of any issues with this. For me, I figured just to fab a bracket to be on the safe side. Since I went with the Icon AAL's, this kit requires cutting the existing factory spring guides to add the extra leaf. Which completly removes the mount for the brake line. The instructions from Icon doesn't even address what to do with the brake lines. Hope this helps.

 

Any 2wd on 2nd clip setting? Just purchased stage 1 and icon 1.5 aal. Looking for input what clip setting I should go on. I'm on sema pro wheels now 17x7 +4 on 265/70/17. Will be going 285's after lift.

 

Bump

 

Eibach stage 2 lift kit with JBA UCA.

 

2nd clip
Deaver stage 3 leaf pack.

 

So I’ve had this setup on roughly 500 miles now on option one and have had zero issues with the shocks. The ride is so much smoother than stock and I definitely recommend it!

 

Hey fellas, need your guys’ opinions on which progressive aal to get with the stage 1 eibach kit.
Im planning on setting the front shocks to the lowest notch and leaving the overload in with the aal.