1st Gen Lunchtable Thread - General Discussion

The Shia thing is the history that won't make it to the books. Legendary.

 

Funny thing is, the variants only apply to the original console.

Only by opening up the console can you verify the type of motherboard the console itself has.

It's posted that you can determine if you've got a 1CHIP motherboard by going off the serial number starting with "UN3".

Though all UN3xxx models have the 1CHIP motherboard, there are some "UN29" models that carry it as well.

Only downfall is, anyone can easily move a console over into another "shell" thus defeating the whole serial number tracing.

The later versions, called the SNES JR, all carry the same 1CHIP motherboard but are wired differently in that they don't produce the signals needed to utilize a component cable. It's only after modifying one that you can, but that starts getting expensive enough.

Here's that cable I was talking about -

 

Getting some exposure via the Skydio 2 FB group to some cool scenery in Italy. This one is from the Italian Alps. Some of these Skydio people really rock! This is the guy's first flight using the beacon to follow him on the bicycle.

https://youtu.be/VH_c1_qeUGs

 

Someone needs to start a thing to gamble in weather forecasts

 

Flying with my 90 year old grandmother has been an experience. It’s been some time since she’s been on a flight and they’ve streamlined all the TSA bs she used to have to deal with.

Bad car accident in the 80s required a lot of limb reconstruction.

 

Shitbox bingo!

 

Man, I only check off a few boxes.

Paint fade
Over 200k
Ignored by Normies
Drum brakes
Panel gaps
Made before 2005

 

I guess I wasn't around in the 80s but I didn't figure stuff like limb reconstruction would have been a thing yet

 

Made before 2005

 

Does no airbags count if your clockspring wiring is bad?

 

It was very basic back then. If it happened now she would’ve been a lot more mobile. From what I understand they went in and redid her hip and some other stuff later on.

 

My truck only ticks one of the boxes. Oof


Drum brakes (I’m talking tundra here)


Eh I guess missing parts too

 

Yeah

You can't call the rest shitboxes if they don't even roll

 

I don’t daily them


I’m really leaning flatbed for the 95 taco

 

Flatbed

Going aluminum?

 

You fuckin know it.


Might flip a few cars just to spend money and go with one of those fancy Summit flatbeds. Or I’ll DIY one

 

DIY

I wanna see your welding

 

You’ll get to see it when I have the tundra exhaust done. Because the long tubes are here. Waiting on gaskets and the 300 series piping. Plus 2 cats. I’m doing half the exhaust now. Then Dumping it after the x pipe. Later I’ll add the mufflers and tail section

 

Might as well say 'may you always have a rock in your shoe'