What Have You Done To Your 3rd Gen Today?

Threw these in today

 

Added the red aluminum start button. Thought the button was too expensive but looks good so… Also did the Meso total tail stage 1. Totally worth it. Looks awesome! I’m almost jealous of the cars behind me. Because they get to enjoy the tail lights more than I do.

 

Got my Meso Stage 1 tail light kit in today. Now to figure out when I'm going to install it. Might be a lunchtime in the parking lot affair.

 

Only takes 10 minutes. Make sure you grab someone to hit the brake and turn signals so you can enjoy the goodness.

 

Met with my buddy Eric from here and bought his tent and prinsu rack off him.
I mounted my roam case to it but it's kinda a bit much to me. The roam case uptop that is . Thoughts?

The tent will probably come off when I'm not about to go on a trip.

 

I've been thinking about placement of the Raptor lights for my TRD Pro Grill from Empyre...the lights don't fit where I want them but I have not tried how you have yours set up.

E
****

 

Your truck has the wiring already there. You can get them from the dealer or Amazon. Should be around $50. The ones you're inquiring about are for pre-2020

 

Got mine today and my truck isn't even built yet.

 

Mine went through all the phases from material ordered to shipped in a matter of 2 minutes. I got like 5 or 6 emails in a row with each phase. That's how I know it must have been a cancelation from another customer that fit my order.

 

It should work with the double cabs. If you have an access cab or depending on the trim level you may need the switch and relay. I didn't need anything but the lights on my 2020 SR5

 

good man! I did the same.

 

Started filling in my Christmas gift- custom 3D printed switch panel for the auxbeam 8-gang. A very helpful little mod

 

I've been looking EBERYWHERE for that switch panel!!! The guy that used to sell them on Etsy no longer does I guess, and his were SUPER clean prints.

 

Huh. That’s odd. My sister just ordered this for me a couple of weeks ago. It’s a very good fit, I will say. The print does look a bit haggered out of the box. But doesn’t look bad at all when installed.

here’s the link I used…
https://etsy.me/3BDTHZs

 

Well he'll, he's back!!! Thanks to your post I looked his etsy up and it looks like he's back at the ol grindingstone. Ordered!

 

Now that my Softopper (finally) came in, I started building my "sleeping platform/pull-out kitchen / Ronco-5000" .

I'm building it out of cabinet grade 3/4" sanded birch with 500lb industrial ball-bearing slides, with a gear drawer, a pantry drawer, a two-burner stove and a utensil drawer with a pop-up cutting board.

 

glad to be of service! This print really is much better then I expected. Not a bad bit of kit

 

Just ordered the Taco Garage dash mount system.. and some Ram mounts!

 

Thumbs up for the innovation and 490cc's

 

Off the inner coupling ring? Once I took the clamp off, I used a long flat head screw driver and rubber mallet and tapped it all around the edge of the coupling ring and it popped out. The hardest part was taking the exhaust tip off the flared part of the exhaust pipe. Had to use lubricant and lots of elbow grease to pull it off.