Shop Time w/T.W. Friends. Rusty's art poll, see post #89179 and vote now for awesomeness.

I need a lathe.

 

I need a lathe operator......ours is out

 

The in and out is the way the judicial system is set up. The original arrest may not have had a bond by the arresting officer depending on severity of the crime. You have a first appearance before a judge 24-36 hours after the arrest where the judge makes sure there was probable cause for the arrest. At that point, the judge can raise or lower the bond or keep it where it’s at. If the defendant can make the bond he’s out until the trial date. It’s not a prefect system and LE has to chase a lot back down.

Dad may not have been arrested if they couldn’t show he was directly involved before, during or after the crime.

I'm not sure what that charge is. Sounds like a negligent manslaughter type charge because someone overdosed and died on drugs tied back to him.

He’s probably “in the wind” as we used to say, on the run and hiding.

 

I'm a lathey sort of guy.. Oh, wait, you meant....


Never mind.

 

The ice hiding under a thin layer of snow is evil!

That tries to kill me all the time !

 

I learned long ago winter weather stay off limited access highways!

I think the first time I sat for 12 hours before the road was cleaned out enough to open.

Nothing like coming down off Elk Mountain and The State Police close the gate behind you.

 

That is just being Lazy !

 

i sometimes think they hype up the forecast to keep viewers watching to see more adds

incite panic buying thinking the next Ice age has started.

 

This happens to me all the time. They close the Trans Canada by the weigh scales near me. I travel the secondary & when I come out the other side the RCMP are right there.
Usual question is “Where did you come from”.
“My Mom” is the usual answer.

 

In that respect I understand and Follow that most other times .

It just worked out that way .The other option would have been long extension cords

Then the only loads were the welding machines plasma Air Compressor and the two phase converters for the Mill and lathe

I am working on getting the drier hooked up for 5 years now!

 

Gonna smoke a butt in the morning.
*not hunting, a Boston butt.

 

Get that sucker up to 205 and enjoy the fruits of your labor!

 

I believe you mean, " Meats of your labor".

 

Missed that perfect opportunity, didn't I?

 

Me too
Shit moved so hard they cracked and broke the lever frame..
Bent all the shift mechanism.


melted cables
Stripped and broken chute gears
Surging carb
Slipping belts

 

Mmmmmm
New IR?

 

If you feel the compressor is too loud get a piece of rubber matting and put under the feet. It doesn't make a giant difference but it helps and doesn't cost much.
I got my mat from Tractor Supply, they have a bulk roll to cut.

 

On my old Chevy truck (new when purchased '93) short box, after picking up a used topper for it I got one of those rubber floor mats for the bed. Bed mat needed trimmed to fit...well, you familiar with hanging on to stuff...might need a piece of that someday there's a pice under each foot of my compressor. They were in place before I ever turned it on.
Got more if anyone needs a piece

 

Few more pictures to share. After turning the second side of plate had about .007" miss match max at one side. I figured it would be but tolerance is plenty.
Signs, signs, everywhere a sign...
What sharpening tungsten does to a grinding wheel. Won't be much good for sharpening a drill bit now.

 

You expect Welders to be able to read?

Only when the clueless sharpen the Tungsten the wrong way.