17" FN FX Pro Bronze Wheels

If you know anyone with a vinyl plotter you can cut your own. Here's how I did my FNs.

 

I have a similar setup. It does throw debris on the side of my truck.

 

Not sure if you noticed, but along with the wheels and tires, the skid plate install (including the removal of the air damn up front) made a big difference in the appearance. This removal is required with the skid plate, so I don't know if the tires would have even fit if I hadn't taken it off.

Either way, it makes the front end appear a bit higher off the ground and really did add to the look IMO. I was worried about gas mileage differences, but it has been very minimal.

 

Anyone have suggestions for the center cap beyond the "TRD" option? I went that way with the skid plate because I wanted the factory one, but I also don't want to build a TRD Bro unit either, so I'm avoiding the TRD moniker as much as I can.

 

Nitto was my second choice in tires. How do you like them?

 

I did notice that too. I'm worried about any changes that might disrupt the clearance. I do like the appearance, though. But I think I will take baby steps with certain mods (TRD Lift and Grill replacement -- I have a front camera on my stock grill -- would be the two main mods that I'm considering but need to be thoughtful about).

 

Loving 'em so far. Road noise isn't bad at all. MPG has dropped but not as sharply as I'd anticipated... and they are a treat to drive offroad.

 

Another happy FN customer.