What Have You Done To Your 3rd Gen Today?

So what exactly did you do?

 

Look closely at the center of the wheel.

 

Put new tires on it. Got rid of the factory junk.
265/70/17 Kenda Klever AT2
Probably my last thing I do since I put in an order for a new Bronco.

 

New battery and terminals

 

Looks really good. The only thing I would change is either red shrink tube or red electrical tape on the two black wires going to the positive terminal.

 

Flew right by me.

 

Engaged pawpaw mode, tomorrow factory running boards installed

 

What should I do when hit with around 20 inches of snow and climbing? Went for a hike at the local state park and got pissed off repeatedly at the locals that can't drive in this weather.

 

I'm just glad what I'm saying is close enough to the truth that nobody has corrected me yet

 

Installed new tires and tested them out

 

Other than the radio buttons, which I suppose I can't do anything about without replacing the head unit, the last bit of chrome has been deleted. AJT 4x4 knob and radio knobs today.

 

Wired and mounted my Warn Xeon Platinum 10s.

 

Nice contrast.

 

I murdered my front skid plate - fresh powder coat and emblem change.

 

Got some Cooper Discoverer AT3 4S's installed, just in time for snow. Went with the chunky 265/75/16 on my stock 2021 SR5. No rubbing or issues so far besides these things really chucking snow and frozen slush chunks all over the place. Definitely needs a bath now - running boards, wheel wells, and doors are plastered with nasty gray snow paste. Very good traction, though.

Glad I got the undercoating done a couple of weeks ago, that's for sure.

 

Multiplied my overland points today. Now have my axe and maxtrax mounted so everyone can see how #overland I am. Finally have a CB antenna again too.

 

"HALF"!

 

Upgraded my rear bumper with a high clearance from At the Helm.

 

Installed the Prinsu Cab Rack (waiting for the light bar in the mail), added the Caliraised bed stiffeners, and added my homemade bed mat that I made from a horse stall mat.

 

Bummer not doing that to the truck to put a after market bumper on. Found a Video of how it is put on. Changed my mine. Guess I keep the stock one way to much new stuff to remove and cut up for it.