Aftermarket Wheel Lug Nut suggestions

Nice.
Wish I'd known about these when I was cutting down H&R's to fit.
You mentioned back axle. Did you go with something different up front?

 

1" longer than stock IRL.

 

LOL
Now I feel better.
Guess I would have to have cut them too.

 

Check this other thread that's going on now for wheel stud info: Longer Lug Studs for 3rd Gen Tacoma? Falcon T8's | Tacoma World

TL;DR: These studs are easier to fit:

$23 Dorman 610-463 Rear M12-1.50 Serrated Wheel Stud - 14.20mm Knurl, 55mm Length Compatible with Select Pontiac / Toyota Models, 10 Pack

Amazon.com: Dorman 610-463 Rear M12-1.50 Serrated Wheel Stud - 14.20mm Knurl, 55mm Length Compatible with Select Pontiac / Toyota Models, 10 Pack : Automotive

 

Thanks for the link, but thankfully mine are done.
My lugs were only getting 5 threads of purchase on the OEM studs.
I ordered H&R's and cut them down.




OEM on the left, H&R on the right.

 

Man you cut those down A LOT lol. I run the H&R 50mm's on my tC for the same issue and they're nice. Didn't even think to check if they fit the Taco when I installed my RAYS. You'd think wheels designed for this platform would be able to properly install on the factory lugs.. but whatever I'm over it now. Was just frustrated with the luck I've had with the truck and ordered from the first site that came up lol.

I debated cutting the wheeladapter.com ones down, but it was easier to drill a hole in the rear dust shields. Up front wasn't a big deal, the splash shields bent out of the way pretty easily.

 

^My thoughts exactly.

My Venomrex wheels weren't even machined to accept XL lugs.
The XL's might have been enough to ease my mind, but as it was, stud replacement was the only option.

 

You're the man, Thank you!

 

I got extended lugs on the rear for a 1/2" slip on hubcentric spacer. I needed it to clear my shocks. I have ET lugnuts all the way around so thread engagement wasn't the issue. I only put longer studs for the spacers.

It says 1/2" on their site but I didn't take a tape measure to them.

 

Yes.. Which is why I got them because that's all I needed. If I would have spent more time searching on here first I'd have seen that that's a big lie lol. I wish they'd just put the actual length instead of us having to do guess-work to know if they're really 1/2".