What Have You Done To Your 3rd Gen Today?

I pointed my ditch lights forward a little more

 

Pictures don't do justice how long this actually took to get right. The Lightbar Kit bottoms out on the Prinsu Valance (It's a mount kit specifically for this lightbar and the Prinsu rack ) I used 5 washers and a longer M6 Bolt on each side to raise the mount up high enough to clear the valance. Now the lightbar no longer spots for low flying aircraft. .

 

Got an idea for you: take that valance off and use it to make a pattern on a sheet of Lexan or other clear UV-resistant plastic, then drop the light back down behind it. Lower profile, expensive lights are protected from highway debris, less wind noise, and more aerodynamic

 

Same here. Along with ARB air compressor and front lockers. Much cleaner now.

 

Busted out the vinyl cutter and made some decals

 

Added a TRD lift, rims and 265/70/17 BFG KO2’s

 

A lot of departments hand out free pistol locks. The Community Service Officer usually has a stash or the desk sergeant may have some.

 

Installed RCI full skid plates and rear differential skid plate. Still waiting for my roof rack.

 

What kind of switch plate did you use to get that flush mount?

 

I get your point - I like it how it is now.

 

I was just checking those out on their website. Those look stout!

 

Check on Etsy for "tacoma switch panel." There's a few 3d printed ones I was looking at.

 

Lol, that works too. It does look good your way. I'll just keep my idea in my back pocket just in case the day comes that I put a roof rack on mine.

 

Griselda has been unbothered with upgrades/mods for quite a few months now due to busy times at work and whatnot.

Today I made time to FINALLY install my @mattgecko LED engine compartment lights. Super simple! Hope the 3M holds up to Arizona summers!



One of these days I'm gonna install a plunger style switch so they turn on automatically when I pop the hood.

 

With the mods and all the off road fun you've had, did you get the expected wear out of your ball joints?

 

this is a Switch-Pros 9100 that I got on TW from @memario1214 via HotShot Off-road. I highly recommend him for anything you need.

The “mounting plate” is a 3D printed driver’s side cubby made by @MESO via Meso Customs. Also the maker of the elusive puddle pods! Glad I was able to snag a set when I did.

 

Paracord headrest grabhandles. Gf commended my thoughtfulness after i told her that her mom mentioned having a hard time getting into the backseat last week but I had already bought them before her mom told me this

 

Part 1 of 3 came in today, the rest projected tomorrow… hopefully


A bit bright so I’ll likely wrap it unless I can find pre cut stickers/vinyl.

 

How’s the flag

I did the leather in mine. Matches the stock leather seats pretty well actually.

 

I did smooth