1st Gen Lunchtable Thread - General Discussion

I’ll be over next week, guy is really cool and is holding them for me.

 

@JKO1998 another shade

 

Got the electrical done today. 98% ready for drywall. Cant freakin wait, already got the paint colors picked.

 

@BartMaster1234

Tyler, I wish I could share the video with you. It's in a private FB Skydio owners network group so I captured this picture to share.

The video is of a guy riding his horse carrying the tracking beacon and being followed by his drone in the Philippines.

 

If you didn’t tell me that was the Philippines I would’ve thought it was in Nebraska or something! Corn is a very uncommon crop over there. Usually we grow rice for grain.

 

Good shit. Make sure you post a before and after.

 

Framing looks good dude!

 

The whole thing is mind blowing.. LOL

 

Its uh, excessive. I haven't done it before so I probably went overboard. And I got sick of hand nailing it so I went ham with the deck screws about halfway through... I dont want to be the guy that remodels it again someday.

 

This is to make the washer and dryer have a space that isn't just out in the open right?

 

Yeah previous owners stuck the hookups in the kitchen.

 

Current owner sent me a pic of the 4R, put an RTT on top and new coils -



Hopefully they settle a bit

 

What locker are you going to run

I was going to get the ox locker they keep saying they're going to release... But they never did

 

Speaking of lockers, I've got a question for those with experience.

@ZUK
@Wulf
@Speedytech7

Say I pull the 3rd from the LC's rear end, I take it pulling the Spartan locker would be easy peasy?

My question then becomes, are there clearances I have to check afterward? Anything I need to adjust?

Would love to pull it, and really go selectable if I did add something in the rear.

 

Your welcome, I'm glad someone is finally getting some use out of them!

 

I love that little welder


No real spatter either

 

Alright I'll bite, the hell is this

 

A bracket that should be on the hitch of my tundra to support the bumper

That someone cut off

That I replaced with a piece of cut up square tube

 

That paint is like $1.32 a can at Walmart and looks good on everything

Welds are as good as flip flops and no gloves running a 120 volt flux core welder turned down to not trip a regular breaker gets