1st Gen Lunchtable Thread - General Discussion

I registered to go to the Texas Lonestar Toyota Jamboree. I can get down there in 3.5 hours and get some good mileage on I30.

It's a closer destination for me. I'll be regeared by then and ready to play.

https://youtu.be/vWrWBZH8VRM

 

Catch up

 

Oh man, the Guac at Chipotle is going up now eh?

 

2010 FJ Cruiser for sale, only seen highway and a few light fire road miles, $75k no low ballers

 

If only he has tons and 40s

 

@Kwikvette https://www.instagram.com/reel/CZIAKIuFHfb/

 

Been and Jerry's has gotten overpriced. $4.29pt
Bryers will have to do $3.69pt

 

Who buys pints? I buy 1.75qt tubs

 

You eat it with your fingers. He eats BnJ with his pinky out and a spoon.

 

We’re at 42° today

 

Trail limo

 

Is this good or bad chipotle stock I wonder

 

So transfer case showed up today. Couple of issues noted and wanted to get some feedback -

Vac tube/line is bent and that piece is discontinued.
Not sure if I can bend it up a bit and be good to go or if its a wash and I'll need to hunt for a replacement.



Next up and I'm guessing this just needs to be tapped/drawed back into place when attaching the driveshaft(s).



This I am a bit worried about, it appears the housing took a hit. Hard to see on camera but its not a smooth/level surface right there. Its not an attachment point but it does need to seal with the trans. What to do? Wire wheel it and smooth out the minor imperfections?







Shaft leading into the transmission and to rear drive shaft spins freely with no issues. Front drive shaft however has some noise to it. Video below, not used to this so need to ask you experts if it sounds normal or not.

https://vimeo.com/677438391

 

Microsoft Word should be listed as an instrument of torture, not a word processor.

 

So I brought this little guy home last week.

This is Ozzy, he's our Black (Sabbath) Lab

 

The internet is a wonderful place.

 

@BartMaster1234

 

Bayliner Contessa or Avanti. Looks like a 25 or 27 footer. 7,500-8,000 pounds. One of the vessels I was looking at in the past