Shop Time w/T.W. Friends

Yep! We're finally underway on a teardown of a diesel backup generator. It's been great to have some work to do.
Everything so far is going good. Today is one day off a week we get. So last night after work stopped in to a little diner for some food, then went down theroad aways to bar so coworker could enjoy a few beers.
I sat there had a coke and watched Olympics.
Time to do laundry and pick up a little more food today. That's about it.
I'm still trying to be quiet so Cory can sleep in some.
Hope everyone is doing good.
I'll stop back later and catch up some. Been hoping that Danny is doing ok.

 

Morning guys. Hope everyone is doing well.

 

What Critter said, how you doing???

 

About the same. I'm still weak and nauseated. Still stuck in this wheelchair. I got 2 units of blood the other day and it seems to help. I've been eating a little better but I'm kinda worried about 2 tests I have coming up. I shake pretty bad, so I'm sorry if ya can't make out what I'm saying.

 

Good morning everybody

 

Please don't apologize at all for anything. Been for you.

 

^^^^This Danny^^^^

Hope your test go good and everything is fine, hang in there!!!

 

A couple of tarps would do it and cost ya less than 50 bucks..

 

Breath Danny..
If ya wanna talk and vent we are here. Start a pm chat with some of the people you want to talk to and let it out. Lots of that goes on Man…

 

Thanks guys, I appreciate y'all's support.

 

No need to apologize, praying for you.

 

Tailwheel bracket getting closer.

 

More carnage! This being the hydraulic motor for rotating the grapple on one of our log cranes.

 

Well, it was

 

I assume you can order new parts for it?

 

It's sold as an entire motor assembly, no rebuild kits available. We sent the plant manager halfway across the state for the only one we could find available. Just finished reassembly and it's back out unloading trucks.

 

Be interesting to do a cost-comparison of the replacement unit compared to @six5crèéd cutting you a new gear!

 

The gear was fine actually, it was the splines on the motor shaft, and the bearings+seals inside the motor that took the shit. Could've used the gear over again, but the new motor came with a new assembly so I'm keeping it for a paperweight.

 

Saaaaaaweet

 

Sounds like Toyota.
Sold as assembly