What Have You Done To Your 3rd Gen Today?

Thanks!

 

The
Do you need an alignment after doing the U-bolt flip?

 

I was thinking the same thing!

 

Installed some Caliraised MOLLE panels on the center console. Easy install, still find it difficult to drill into a new truck!

 

Was unaware of that (New to Tacomas) On my list to do! Wasn’t as deep as it looks. Thanks for the heads up

 

That looks cool, been looking at those for the bed.

Struggling with something similar. I really want a set of wheels. But.. I absolutely do not want want to cut the cab mount. If I have to do minor trimming, I'm fine. As long as it isn't noticeable. Unfortunately I've read most of the wheel threads here, and all I've managed to do is confuse myself further.

 

Not if you don’t do anything to the centering pins or leaves themselves.
Other than correcting actual problems the thrust angle isn’t adjustable anyway.

 

All red inside now. Map lights last week and today i got the dome light done.

Small things.

 

Getting rid of this

 

I'll have a talk with my cousin Dave about that. He'll pass it on to the current CSAF, and then I'm sure you'll be compensated...



(btw, Dave is Gen. Goldfein, Ret CSAF 21 (Fingers))

 

That's where/who I bought the truck itself from, back in '17.
They also provide me FREE tires for life! (As long as I don't purposely abuse them (i.e. donuts in the parking lot).)

 

just tell him I'm an AMMO troop, he'll probably agree

 

Do one side at a time, complete to the nuts torque-down. The opposite side should hold the axle in place.

 

Looks great!

 

Yes I’m the same with the cab mount with wheels. I find it hard to make major changes like that to such a new vehicle. I think I’m going to go with taller/skinny tires with a -12 offset to hopefully avoid doing the chop, I’m not sure it will work though!

 

Did you need a different mounting bracket to attach your Caliraised light bar to the Prinsu rack or you used the ones that comes with the light bar?

 

SSC1 sports installed as DRL

 

I'm hovering around a 8.5-9" wide wheel, with a 0 offset, stock tire size. Pretty sure I'll be OK with that. Ideally I'd like a little poke.. not sure I can have it though.

 

It's pretty... and the badge is pretty great as well

 

Well i just spoke to my Toyota rep and they are going to get me a TRD Pro grille, because I've waited so long for my sons Tacoma. and i guess its good will that the last 6 vehicles we have purchased from the same dealership.