1st Gen Lunchtable Thread - General Discussion

Aaaaaye Brent Crude just broke $100/barrel


And I guess Russia did a thing?

 

120v is plenty enough for what goes on these trucks

 

Never said anything was wrong; just stated it'd be my personal preference to run stick over MIG if I wanted penetration on some thicker stuff.

 

In hoodies we trust

 

Next set of sliders I weld will be with the 120v harbor freight flux core welder than dropping it on cinder blocks With an engine hoist for science

 

Look at this clean fancy camry

 

i literally cant get a single soul to move this frame.

 

looking clean!


What tonnage is that press? And is that 1/4" thick?

 

Where is Marie?

 

I paid 80 bucks to fill up the tundra

 

@0xDEADBEEF

 

Send you a RC frame

 

Tell me you didn't have adequate insurance for your Tesla without telling me?

 

But... The zebra helped me save $18 a month

 

I only have that one because it's one of the few the FE/PE exams allow. My main is the TI-84 Silver and I have the n-spire for when I'm doing a lot with j values and phases

 

Fiesta auto insurance >>

 

My spring breaks coming up

 

Oh the FE

It is OTW

 

Do it now, don't wait. FML, I need to start studying. My 5 years is coming up. Gonna try to take them both out at once.