What Have You Done To Your 3rd Gen Today?

My daughter put these on her 16 they fit but took some pressure to get them on.

 

Tacoma World, helping me spend my money again!!

 

Took the opportunity to install my VLED footwell lighting kit. Only one hiccup, and that was putting the A-Pillar cover back on... The small white clip that holds the cover to the pillar came off, and went down into the dash, and eventually behind the driver's kick-panel... It sounded like I was on Price playing Plinko.

Love the lights (aqua) at night, but would have preferred a white when the dome light is on. But since I don't spend a lot of time in the truck with the door open at night....

 

couldn't he just open it?

 

If your flexible....why bother. Don't really need to open the cover to slide some bags in.

 

yea it looks normal

 

Thanks man! I remember seeing this here. I just did the engine and transmission skid for now. Debating on the exhaust reroute before doing the transfer case skid since that’s the one that can make contact with the factory exhaust routing. If I forego the reroute I’ll definitely keep this in mind. I believe RCI has an option for the rerouted exhaust when ordering the TC skid. Much appreciated!

 

Yeah that dude don't look like he's very flexible.
Looks more like he's stuck!

 

Yes I did. It’s in my build thread. Page 1, 3 & 7

 

Finally, no more squeaks! Ugh, word to the wise, if you do a CMR, pony up for the premium bushings first.
Also, these bad boys arrived! Can’t wait to start the BHLM. Clear lenses and tuned!

and.. a few more stickers

 

Finally gave my 21’ dc sb army green trd OR a good thorough wash… it’s got 4000 miles now and still had some adhesive on the fenders from the factory protective film… weather hasn’t been great since purchase and it’s been bugging me for months that it looked like scratches on the fenders, gone now. Perhaps some pictures tomorrow.

 

Looking forward to seeing the final product.

 

The “premium” is an Energy Suspension bushing?

If so, the DRT CMR comes with them: https://www.drt-fabrication.com/product/cab-mount-relocation

Picture added, for comparison sake

 

Worked with @empty_space on designing this PCB to work with my shift knob illumination mod and @MESO stealth switches or any momentary type switches. It also has an input to parallel the flashing security light when the truck is off

 

53114-04250

 

In handicapped parking? Not judgin’.

 

Yes, he has no upper body.

 

Had a productive weekend. Installed RCI sliders, Pro skid plate and Pro grille (still undecided about whether I want to add “raptor” lights or not)..

 

Nice project - I did the same in the fall. I ended up adding raptor lights - I couldn’t resist. I have them in a switch, so they’re not always on. When you did the front inside frame mounts for the sliders, was your frame full of white lithium grease?

 

Thank you sir. Just curious - When you installed the raptor lights did you disconnect the battery? I’ve heard people recommend doing so.. I suppose I’m just a little hesistant to mess with anything electrical on my “relatively” newish vehicle.

And to answer your question - yes, there was some grease, but it was a very small amount.