1st Gen Lunchtable Thread - General Discussion

That woulda been my second guess, that many mega ohms is usually an indication of a short through a case somewhere.

Have you ever used one of those radio signal senders/receivers to trace a break? Makes it sooooo much faster and easier

 

Also who ever ran the sensor last time used the wrong one so it was never accurate to start with…

 

No havnet done that. Typical if i find a bad wire and i can fine the break i just run a new wire. Also on sensors I typically dont like to have splices. So when i can I always do a continuous run

 

Smart. You're a good tech

 

It took a few looks at this to figure out that you're not actually testing the resistance of a piece of raw chicken...

 

Sp rn o have a sensor hock up the the controller so the case runs while i wait for hella product to get pulled so i can pull a new wire lol

 

When I first looked at it, I thought he was working on his smoker at home

 

At least it's running, I'd hate for them to throw all that meat out

 

Ive seen store through the whole store out because it was down a little to long

 

Just turn the compressor on backwards and turn it into the worlds shittiest cooker, problem solved!

 

We would get into alot of MacGyveresque style trouble if we hung out in a garage together

 

Probably make eveyone in the store throw up lol

 

Sad noises

 

I don't even dare post pictures of the adapter I made to hook the welder up to the dryer outlet .

 

@Abeyancer

 

A can of ro-tel tomatoes with some garlic, dried onion flakes and other stuff is better than some restaurant salsas I've had. Sad sad.

 

When your rental house has concrete walls and the only outlet in the garage is the 10A one for the garage door, creativity really takes off.


All in all though, its pretty safe. Built into an enclosed box, properly grounded.

 

Get a 05-current frontier and put titan suspension for cheap lt

 

Cant be as bad as this