What Have You Done To Your 3rd Gen Today?

I see what you're talking about, but...it doesn't bother me. It's better than looking at chrome.

 

Do you do and sell custom reflective decals?

 

i don’t, I just use a cricut and make them. What are you looking to do?

 

finally got around to installing and wiring up some switches. still have not got the mounting brakets (or made them not sure yet) for light bar on the back and the air compressor so they are not hooked up but i did a shitty fab on a bracket to hold a breaker fuse holder and relay holder. there are some things i learned and will prolly do a 2nd one with a few improvements.


One thing i need to work out tho. the bottom independent light. i read i can tap into the brown wire that goes to one of the things already right there so you can have the dim capability's.. it does not dim tho. also when i have headlights on it turns bottom independent light off. So im going to have to search through the forums and see if there is a solution before i start a independent thread.

 

if she's 4-11" let me guess... you are 6'5"

 

Supposedly Dim is on the negative Don’t know if that’s the same wire you’ve tapped or not

 

took this from a TW thread i found on google

used 3 for ground and 4 for pin 6 on the otrattw switch.

 

Yea I think I could squeeze them in together. The wife would like another Miata as much as me if not more.

 

Pulled the rear seat backs and cab panels, installed

Siless Hybrid 3in1 200 mil 36 sqft Car Sound Deadening mat - Butyl Automotive Sound Deadener - Noise Insulation and Vibration Dampening Material

Siless 200 mil mat on the rear cab wall and area under the rear seats. Wrapped a piece of 1" foam pipe insulation over the cab vents to absorb sound but still leave a gap for airflow. Also lined the side panels covering the rear pillars and the rear panels. Wish I had done decibel readings prior to so that I could see the true impact, however this did make a significant improvement and to me was well worth the effort and cost. Will be doing the doors, floor and roof as time allows over the summer.

 

OEM Wheel Locks, in black.

 

Good question, it was a few years ago when I ordered it but I do remember emailing them a few times and they were usually really good at responding. They’re on TW too, it could be worth it to message them here too if you haven’t already.

 

I heard back from them today. They said that it just got back from being powdercoated and should ship out this week. Now seeing your truck, it helps me visualize how mine will look. Thanks for posting.

 

I am about to do the same. Which clone-able TPMS sensors did you end up going with?

I used the vinyl inserts for the 4Runner wheels that TVD makes, they pretty nice. They are about $10 and they run a lot of promos and I think they also have a TW discount. They are easier to install off the truck so you can lay them flat.

 

If you live in a high crime area or theft is a concern get real wheel locks. They're a lot more expensive but it actually works. Those you have on can be taken off in seconds with a socket. All they do is make your day more difficult when you cant find the key for it

 

You're a legend for doing this, thank you man!

 

Beat me to it. thanks Sir.

 

Put in the glovebox organizer insert. Works well for what it is.

Rant: The cup holders right behind the gear shifter are POINTLESS. Nothing fits in the damn things. My phone doesn't even fit let alone a larger drink

 

Manual or Automatic? I don't have any problems with the cupholders on my manual.