Fitting 35’s with minimal trimming NOW ADDING LONG TRAVEL AND 934 CV’s

We limited mine where I would need to monitor bump pad wear lol.

 

This is what happens when king and fox have a baby... you get 2.0 free bleeds

 

Most disturbing thing you've posted in awhile.

 

I knew you would appreciate it

 

You going to use 5/8" or 1/2" tubes?

 

5/8

 

It would be awesome to use the fox tool less adjusters with free bleeds.

 

King already makes the same thing

 

I didn’t know that. I was searching forever a couple weeks ago. Probably would of helped if I had called and asked lol

 

Sorry @desertjunkie760

 

Should have gone with a bigger hose for a 7/8" shaft.

 

I just used what fox supplied these shocks with for decades... hopefully they finally figured out that the hoses they used forever are too small

 

Is my thinking correct that the resi being mounted low on the body has a substantial benefit over being off of the top cap? I've had theories in my head for a while, just never really asked anybody.

 

From what I’ve researched, it helps on compression dampening. The piston doesn’t have to fight with a variable area where the nitrogen is. Also read that the nitrogen section would not see spikes in pressure from the compression stroke. I guess it creates more control on the compression. At least from what I read about it.

 

Or maybe the Fox engineers know a few things that I don't and the hose is is more than adequate. I am just an idiot on the a public forum.

 

Ahhhh, aren't we all.

 

I’m not an idiot, I just play one on the Internet

 

And I must say, 10/10 performance. Very convincing.

 

I’m not an idiot, I’m a dumb welder

 

well at least you have an excuse...all those fumes you huff daily