What Have You Done To Your 3rd Gen Today?

Installed RCI sliders today, these things shipped 2 days after ordering. Install wasn’t too bad, I did have an extra set of hands though.

 

Sweet! Are those the 0° angle?

 

It’s perfect for throwing paddle boards up there!

 

Any chance of a side view shot? I’m curious to see where they start and end. There was another member that looked shorter than normal.

 

These are the 5°

 

I’ll get one when I’m back in the truck this weekend for ya. Gonna be in the RAV4 for a couple of days.

 

Nice! I was wondering because I ordered the 20° two weeks ago and they have a 4-8 week lead time, on the shorter side for my DCSB. I have the SSM TRDOR like yours. Looking good! Now I’m extra pumped about these!

 

I saw that too. But although they didn’t cover the couple of inches rear of the cab it’s irrelevant. It’s a matter of physics, once you have reached the end of the slider towards the rear tire your rear tire will be in contact with the obstacle, unless it’s pointed like an arrowhead.

 

For only $389!

 

Save your money.

 

Those look so good!

 

Added rock lights. (Took me all day to mount and run all the wires). there are 12 lights total.
I'm doing the "negative" dependent so I can hopefully hook it up as courtesy lights with the Dome circuit.
I wasn't going to light up the fender wells but I had the extra lights so I figured I'd just install them all.
Hopefully I can get it to work as courtesy lights also.

 

man that’s sexy! Well done looks great!

any photos of the wiring under the hood?

 

removal of visor stickers:
heated the visor up with a small space heater,
worked a corner up enough to start peeling slowly,
after sticker gone glue residue left so,
rubbed with some 50 alcohol - got some of it but,
put a clean piece of t shirt over spot and ironed it for 15 - 20 seconds,
one sticker had more glue so re ironed with clean piece of shirt a couple more times till it looked good,
did this at night and was going to get goo gone tomorrow but iron worked good,
other side tomorrow
spot shows more in pics than in person

 

No not really it's a "Rats Nest"! I need to clean everything up after I get it all squared away.

 

I’m between the sherpa and Uptop roof rack

 

Never would have thought of using an iron.

 

I have not tried my head liner but putting some here

 

I did the tweeters, how much of a pain in the ass are the doors?

 

TRD PRO GRILLE, i purchased my grille from Yotaverse and i received the grille but when i put the tss sensor panel in front, it doesn't seem to fit tight in the location and the spring clips dont hold on tight, would anyone recommend any way of ensuring it stays in place? i think i saw somewhere in the thread that someone said to melt the tabs in place? Advice Please