What Have You Done To Your 2nd Gen Tacoma Today?

Mounted the US Offroad hidden winch mount and winch.

 

I'm paranoid so I disconnect the battery first.

 

Made a screen for my front slider in the camper shell and relocated my bed light switch since my cubbie sits beneath the plywood now. Ready for Death Valley next weekend!

 

Checked my wiring on the new harness and everything is good.
I need to pull panels on Sunday and check the length on the wire going to the inverter.

This harness is ready to be installed.

I may have to add one wire but I doubt it. The negative side of the illumination for the steering wheel controls goes through the navigation head unit. That's how I have it wired but I have another EWD that shows the negative going right to ground.

Maybe there is a way I can bench test it.

 

Wow kudos to you that's a lot of work!

 

I'll be pulling the interior panels today and then going through the large amount of reference material I accumulated while doing this project.

 

De badged & de factory- stickered Will get a price tomorrow on having the topper wrapped.

 

RSI EvoA installed Friday. LOVE IT!

 

I have to change a couple wires so I have to un-wrap the left side of the harness and then re-tape it.

If anybody is looking for electrical tape very similar to what Toyota uses but does not want to spend $25 on a roll.

https://www.amazon.com/Nitto-Electr...N?keywords=Nitto+2101TV&qid=1647792082&sr=8-1

Nitto tape, $2 a roll

 

Wheelers extended brake lines

 

LOVE my spotter mirrors.

 

I like the radio mount in the liner. Good place for it.

 

I plan on replacing my sway bar end links in the next couple of days. Another thread said that I shouldn't need to jack up the vehicle and could leave the wheels on the ground. I'm a skinny guy and have crawled underneath and clearance doesn't seem to be an issue. Should I be able to tackle this by just crawling underneath? Any issues I may run into? I prefer not to have to drive across town to grab my floor jack from storage.

 

Taking apart the interior so the harness swap will be that much easier.

 

Ordered 2015 Pro headlights
$328 shipped
46% off and free ship
https://parts.jimellistoyota.com/p/Toyota__/HEADLAMP-ASSEMBLY---LEFT/63161583/8115004221.html

 

Its going to be A LOT easier with the wheels off. you can access them underneath but if you take the wheels off they are right there and super easy to get at. I would get your stands and jack and jack it up. Or use your factory bottle neck.

 

Mine has a bit of a warp it in. Might be because I had to work it for like a half hour to go on but I'll see if it go away or contact them about it. I feel like it was way to hard and something isn't clearing so I might have gotten a dud. (Story of my life)

 

Another add on to the truck... some Baja Design Pod lights. Again, still not done purchasing stuff for the truck lol

 

Sounds like it. Mine popped right on.

 

What a day. Started off deciding I didn't want to give Leer any more free advertising.