What Have You Done To Your 3rd Gen Today?

This is a great idea! Do you happen to have a parts listing?

 

Yup me too. For some reason I just saw that truck and said I want one......

 

Take a look at Wheeler's Ubolt + Superbump kit.

 

This is a great idea. What lift did you use?

 

Today my master bathroom sink drain broke, AND the toilet seat snapped in half as well. Then the toilet chain broke and i couldnt flush.

I just finished fixing all three, the tacoma drove me to home depot for parts.

 

Sounds like Monday Part 2! Good to have the skills for home repairs though , especially plumbing! The rest of your day has got to be better!

 

You are going to HAVE to move your brawls to the outside.

 

As does yours!!

 

New tail lights looking nice in the sun

 

What did you use to match the threads in the Yeti? Do you have a pic of that little adapter creation? That is genius for our FJ's.

 

There's a CAI air box mod sticky around here somewhere that I followed. Can't find it at the moment.

Air Accelerator (rubber funnel) + Re-usable Filter + Silicone Hose + Remove Secondary (cheesecloth) Air Box Filter

is what I did. It DOES make a difference. When I first got my Tacoma, it had a sort of hesitation. I would start off from a stop just fine, then it would fall flat on its face for a second. Did this mod and the problem went away. Don't know if it was a direct result of the mod, or indirect by causing the ECU to compensate for what I did or something.

The silicone hose just seemed like a good idea. Even the TRD PRO hose has corrugations, which I would think would cause unhelpful turbulence. Maybe not. Dunno'

Take whatever money you've saved over the kit, get some red tape and TRD stickers for the top of the stock air box.

 

I'm typically a fan of less is more, but the mesh portion of the sport rack looks like a perfect candidate for the TRD emblem everyone is putting on their grill.

 

Tail lights look sick man, and where’d you get those mudflaps?

 

Yes this is the one.

 

Wrong forum for that sex toy

 

No issues with opening or closing the cover. I can easily roll up by myself through the gap between the bed side and bed rack. I’m not sure about water seal yet because I live in AZ. I can take it through the car wash and let you know. I did add butyl tape in the front corners. The foam blocks you add do a good job with the gap between the front bed rail and the side rail caps but there is still a large gap underneath between the bed and the bed cap. I attempted to use butyl tap along the sides of the bed rack adapters but found the seal to be better without it. Also, do not use any of the supplier foam for the front rail EXCEPT for about 1 inch on each side that goes under the front of the aluminum tonneau rails (there is a small gap and the thinner foam will fill it). The front bed rail sits higher than the side rails so you will have a more flush seat of the rubber on the front of the cover by not using foam across the front rail.

 

I made a cup holder Radio Charging station. Always handy and always charged.

 

50K on the OD or: How I Stopped Worrying and Learned to Love Out of Warranty Repairs.