What Have You Done To Your 2nd Gen Tacoma Today?

Spent a while messing with the pre load to get it where I want on the new coilovers. I believe I have it set perfect for now. Still messing with the high and low speed clickers, which is fun for sure. The ride quality is out of this world. The front is keeping up with the rear, if not outperforming it now.

 

Black ice-1 taco-0

rip

 

Hope you're ok. You can buy a new truck.

 

Got the DD SS3 pros installed and aimed. Just need to check them again in the dark.

 

How do you like the RAM mount for the phone?

 

Skids are RCI Aluminum. I try to save weight where I can.

 

Panel is done. I need to sand a little at the top and buy a couple small brackets to mount it.

 

Sorry about your truck man, but thankfully you’re here to post about it. Truck did its job.

 

Finished panel.

 

Did the ECGS bushing out of precaution since I just lifted my truck.

 

Did you do the diff drop and sway bar relocate at the same time?
I waited to do my diff drop and I tore a CV boot.

 

oh gosh, sorry for your loss.

 

That the warfab rear bumper? Been thinking about going hc rear

 

I did the sway bar spacer but I didn’t do the diff drop. I read a few horror stories on people hitting stuff so I’ll rock it as is. My axle boots are ok. Not touching but I might do the mod where you stretch the boot out a bit

 

Had a good Saturday afternoon
Replace front brake pads and rotors
Rotate tires
Drain and fill rear diff and transfer case
Ordered a new front diff drain plug (Lexus version) looking too crusty to mess without a replacement

 

Yeah it’s the @WarFab Armor bumper. It’s been through some abuse and help up absolutely fine, love it.

 

Hitting stuff wasn't my concern, I didn't think I needed it but I did. I have a RCI skid plate that allows for the diff drop already.

 

Took a cruise on the beach

 

Oh Man, glad your okay. How were the condition of your tires? Also, finding a replacement, now that may be painful.....

 

You rear end a flatbed? ggezzz