dash looks like a Christmas tree

pretty weird, any ideas ?

 

Were you in 4low?

 

Spoiler alert... I won't be much help here.

Since it's a 21' just do what the display says. And send some of that weather this way.

Related issues:
https://www.tacomaworld.com/threads/2wd-4wd-mode-change-malfunction.675676/
https://www.tacomaworld.com/threads/2wd-4wd-mode-failure.461086/

 

Yeah, a little more info would be helpful. Can you describe what you doing / did when this occurred?

 

i didn’t do anything lol i just put a 4 inch lift on it last weekend and the light came on monday

 

nope

 

Yeah personally I'd rip apart the dash and see if I can track down the source of the malfunction based on advice I get on a Forum! Screw the warranty!!


LMAO!!


Seriously!!!!!!
Take it to the dealer. Don't mess around with a Brand New truck

 

will do thanks for the help

 

Seems to me like a connector became disconnected some how

 

Wait you put a 4" lift???

Is it a DB lift?

Maybe they damaged the ABS wire?

 

it was a DB lift l, i checked the the wires none looked cracked or damaged from my eyes

 

You extended the brake lines right

 

Stretched speed sensor wire or wheel sensor itself.

 

yeah

 

Well most DB lifts replace the spindles and potentially damage the ABS sensor while removing it. (It has happened before) the wire internally might be broken and intermittently malfunction? Or the wire wasn't properly relieved of strain of the extra travel cause it to over extend?

 

Not of the most help but there was a connector manifold for the 2nd gen that was near the oil pan and mine came loose during a lift as well. Not sure if 3rd gen has this but worth a quick check.

 

Take it back to the shop that did the lift! The dealer will charge you an "arm and a leg" to diagnose the problem because they will tell you the lift caused the problem!

 

You did do something. You did a major something.

 

i don’t do tacoma stuff with my tacoma so a drop bracket lift seemed perfect

 

Not necessary for a 4"- 6" lift. But you need to relieve the stress on the lines and wires properly!
https://youtu.be/6prhsZHeZT4