For Stock Rigs Only

I need to fly him to Alaska to do my trim work

 

morning Bill & stockers!

 

Great story - thanks for sharing CB!

 

What ?

 

So I've been working on this project for the past few weeks. I have a bonus BR and 1/2 bath above my garage that's accessed via a set of stairs off my kitchen. This area had become the dumping ground for all of my camping, hunting and fly-fishing gear. I've got some new/used furniture that'll store all that now. It's the last area of the house that's yet to be renovated. Apologize for no before pics. All the trim matched the hardwood flooring. Both BR and bath had wallpaper from the 60's on most walls, any painted walls were colors from that era. The house chimney runs right behind the wall next to the closet, and there had been water damage in those areas back in the 80's, the plaster was all stained, cracked and bumpy. That got all cleaned up. Painted the stairwell too. I scrapped up the original linoleum in the bathroom floor. The closet door must have been a single door at one point, thus that gap in the flooring. I plan on weaving new flooring into that area to clean it up. Installed all new outlets, switches and light fixtures. Here's some after pics. I've been patient and used all "oops" gallons of paint for various retailers. $10 was the most I paid. All good quality. Bath is getting a grey vinyl laminate floor, new toilet and a small 19" vanity. Doors are all painted along with new hardware, just haven't hun yet.

 

Sweet

 

More work on the boat today.
See if I can bend an axle…
Or arrange some hooks
Or re spool a 1970’s bait caster for @Sig45 to try.
Or vacuum the deck

I think my consistent 4 day gym weeks are over for the summer..

 

Nice job ! I am always checking out the paint leftovers at Lowe's myself...

 

I am going to my storage unit with most of my winter clothing..Going to put my Taco on jack stands and try and figure out my front brake problem...I'm leaning towards the pistons not retracting, but won't know until I get her in the air...At the moment, I'm going down to the dock and get some pics of the Bass Masters tournament that they are about to cut loose

 

Slacker.

 

Naaaaaa
If you bird nest that reel you will be hopeless. I have plenty of spinning gear for ya.
Lol just saw the name on the baitcaster. Speed Spool you ain’t kidding

 

Wait till you get my age. You’ll be lucky to put your pants on without falling over.

 

Anyone good with a metal cutter/grinder? These baseboard heater end pieces are right on the subfloor. They should be on top of the soon to be finished floor. I need about 1/4" removed from the bottom. The caps are removeable.

 

Going to have to paint them if you cut them

 

Well ya! 140

 

i have 3 different hand held cutting wheel setups.
Your welcome to stop by and use them.
I have files too to get them the way you want.