What Have You Done To Your 3rd Gen Today?

Damn that looks great! very clean.

 

Meso Customs LED map lights, FHF visor organizer and AJT key fob.

Lynn

 

Yeap, straight on you may not be able to see the best perspective during parallel parking, and you're going to catch more bugs and road debris on the lens.

 

Runnin4tacos skid

 

Thank you

 

Nice trim job. What tool did you use to cut that? Was there any cutting required to install that awesome front bumper?

 

Thank you! I admit, that was probably the fifth or sixth iteration before I got what I thought was a clean design.

Funny you mention that! I thought that's what I wanted, but then I realized I could see right about where the camera couldn't so I considered it a win.

 

Snapped this old workhorse in front of me at a Timmys. Wonder where he got those custom duck tape tail lights. Lol

 

I used the Ridgid cordless 3” cut-off wheel tool. I love that thing. It’s much better than an angel grinder.

I did not install my front bumper, but I did cut and install my rear high clearance bumper

 

Picked up some steps/rails.. previous owner modified them so they were closer to the body!

 

Continuing the path if an OEM plus build. Washed my truck a week ago to rid if of salt and brine from the NE and make a recovery kit out of a gun case I had laying around.

 

I’ve got the same steps, can you show where and how they were modified to bring them closer to the truck?

 

ooohOOOHoooh!

 

$200 K&N 57-9039 K&N Cold Air Intake System: High-Flow Air Filter, Increase Performance & Towing: Compatible with 2016-2023 TOYOTA Tacoma, 57-9039

K&N 57-9039 air intake system along with the TRD intake flow accelerator(PTR03-35160-AE.) K&N kit comes with a high flow air filter and intake tube. I was looking at a Flowmaster kit, but after doing some research, realized I needed a CARB compliant kit here in MA. This was the only one I could find. I don't really need the extra HP or noise, but am hoping to see a slight bump in mpgs.





I have no idea what this giant box attached to the factory intake tube is for, but I'm hoping it's nothing important.

 

Ordered the lock kit for the truck bed on black friday and finally got around to feeling like it was warm enough to install it. Kind of a PITA tbh without lifting the truck and should've just came installed.

 

Your fire extinguisher might fit in a door's drink holder. I got mine in the rear driver seat. Could be useful if you need it quickly

 

It gets smaller the longer you own it.

 

Following up here using the Blaze Off-Road mount with some pro tips:

• Get the bus bar and fuse block and mount them with the switch
• Reorient the switch so the positive lead comes out toward the cab
• You need a washer to secure the Cali Raised fuse holder with a smaller diameter nut (M6)

 

New longer brake lines and diff breather extension.

BUY THE WRENCH - I almost didn't get one fitting off, three went fine, last one of coarse stripped a little. After getting a flared wrench I almost didn't get it off - just go buy a fleared wrench.

More slack at extension, now the electrical lines/loom are the limting factor, although since more in the middle should be arrected less by a stuffed, droop situation.

 

Can't just pass by calm...

That's what SHE SAID!