Shop Time w/T.W. Friends

I thought that was high blood pressure...

 

For all those of you who appreciate machine-shop skill, another channel I follow (and learn from). Keith Fenner & Turnwright Machine Works.

 

Had some good help, we done! Didn’t bother with the tractor, we shoveled and wheel barrowed it all.

 

Got done just in time for a beautiful sunset.

 

Well done, Team Creed! Looks good. Can you send the labourers up my way? I've got a fair of shovellin' and spreadin' needin' to be done.

 

Past Tech with Rusty e-bay edition. ($35!)

Wisconsin 2 cylinder exhaust manifold, this is a special side dump - vehicle application, hard to find. These were used in an application like a forklift or Cushman truck where the operator sat over the engine or perhaps in a genset application where a lower vertical clearance is desired.



I already have an engine or two with the equally hard to find rear dump manifold, same applications.



The very common standard equipment manifold goes straight up, usually topped by the "flying saucer" muffler. Units like this with the "house" in Wisconsin terminology are called Power Units.

 

If Cole lived next door to me he would never be short of spending money!
Nice job crew!

 

same stuff i got

 

Im telling ya, he works better than a lot of "Adults" ive seen

 

brother!

 

I work with 750 people, he works better than 749 of them.
Well...750 actually

 

I'd get asked how many people work at my plant?

I'd say "maybe half of them".

 

Or less!!

 

Hey all, it’s been a while. Look what I picked up today! It’s no bass tracker but it’ll do the job!

 

You don't have a dog, do you?

 

@six5crèéd @RustyGreen @tirediron @koditten

Part of small Toyota graveyard near me...

 

Wonder what is lurking inside (or behind) the building?

 

Theres a few more vehicles to left and right of pic. I too wonder whats in the shop...

 

I bet it's full of old signs and license plates!! Go check!

 

Bet he doesn't have one of my signs, though.

Lol.