What Have You Done To Your 2nd Gen Tacoma Today?

They were only rubbing in one spot on the inner part so I may just cut that part out and reinstall. But if I decide not to use them I’ll let you know. I’m in the Seattle area though.

 

Replaced the OEM with new UCAs.

 

Picked up my fifth RPT1 from Discount Tire with tire mounted (their inventory was off and they didn’t have the last tire on hand on Monday) and had them swap it in for the spare. Any recommendations for securing the spare?

 

Truck Norris
Damn near spit my coffee out

 

A few of you may get this

 

Man, I like that holder. Looks pretty simple to strap down stuff.

 

Gave my truck a bath and bought it some gas

 

Everything!!!

 

Here’s a mall crawlin booty shot for ya

 

It's growing on me. Looks much better in person imo. Definitely going to have to trim more though, the wider offset is causing some rub. Not much left to trim, time to break out the hammer

 

Really? “Do skittles come out the exhaust?” made Mt.Dew come out of my nose when I read that! Burned like hell to!

 

Finally did the UNI-Filter “mod”. Peace of mind for the 2nd Gen!

 

Finally got around to change the transfer case and front diff fluid at 128,594

 

I just did mine at 150k (after exploding my rear diff!)

 

Received my bed mat.

 

New high scores on both parts! I feel bad for you west coasters .

 

oof, I bet that smelled great.

 

I finally got my head unit installed in my truck. Crutchfield send me a bad wiring harness for it. The new one I got yesterday works perfect. I still need to figure out how to set everything up on this and finish wiring my camera but Androidauto and Bluetooth is so much nicer then using an AUX cord every time. Couple things I am bummed about though. The dash kit didn't fit the best. I had to Dremel down the area around the hazard switch so it didn't stick and hold the button in and the whole thing looks like its just a little to tight and doesn't want to be in there. Also the dash kit is a little fatter at the bottom and I now can not get my TechDeck reinstalled and lined up into the original holes I drilled into the side of the vent plastic. But I was planning on painting them so I guess now I will just have buy the black ones to replace and keep going on blacking out the interior that way. One thing always leads to another.