What Have You Done To Your 3rd Gen Today?

Installed Square One Creations Frame Caps. Also put in a Guild Outfitters in cab 400W / 120V power outlet.

 

Honestly don't know.

 

I looked at these but some of the reviews had me a bit worried. How do you like them and do they feel like they will last and not damage your hood with only one bolt attachment?

 

Ordered my taco a fumoto vale.

 

Sweeeet!!

 

Went on a little ride after installing my new wheels and tires.

 

Thanks for the info, I'm going to do this someday. Hopefully this weekend, I really dislike all the propaganda in the cockpit.

 

I received the door handle covers yesterday, and added the vinyl overlay to the drink holder surround Sunday - that’s the last of the obvious chrome, other than the Hurst stick that I like showing.

 

here is the oem part number for the door sill protectors:

$45 PT7473520102 Genuine Toyota Parts - Door Sill Dcab Taco (PT747-35201-02), Black

PT7473520102

 

I had not heard of the frame caps…..my wallet just flinched as i saw your post lol

 

Nice

 

Picked up my friends 2000 miles used tires.
500$
Got to order the last wheel and lugs then im ready to go.
Can i transfer my TPM or do i need to buy new ones.

 

you wanna keep your tpm’s. Americas tire and discount tire will program them to your truck for you when they install them and mount/balance your tires

i did the same thing you’re doing on my last set of tires, just take it all to americas tire or discount tire and have them do it all

 

Did you remove the surround or just schlep the vinyl in place? It’s the last of my chrome too and just been avoiding it

 

^^ what he said, although I have heard some aftermarket wheels require I different shaped TPMS so not sure I’m your case

 

Thank you.

 

I like that! how much and where? @chuam

 

It’s really easy! Just go slow and low, checking the visors often. They will peel right off, and a paper towel under the same temp iron will get rid of the residue no problem.

There’s steel and aluminum tpms sensors. Only difference is the angle of the valve stem. Steels are greater angle. I’ve read around here that you can install the steel sensors in aluminum wheels, if you flip them “upside down” (180 degrees), but that some tire shops aren’t into that.
Installed a set I bought from a member here just today, after finally locating the right sensor service kits. He sent them without valve cores and two were missing washers, but Napa had the service kits 4 for $15 so no biggie.
Now I’m just hoping the sensors are all good! He said they were off a ‘21 so fingers crossed!

 

We have a family run tire place that will do whatever i ask. Just hope they fit.