What have you done to your Tacoma today? 1st Gen Edition

6 spokes for 6 lugs is prime. Looks great!

 

Wasn't aware curiousity was considered anger now a days.

The spatter is annoying but don't think it would be much of an issue being that you're welding on the opposite side to where the cam sits.

 

It's not I'm just giving you shit. Flux core has its place, I don't bust it out unless I'm welding outdoors and there are literally no other options present.

 

Raptor Lined front/rear bumpers, grille, and fender flares..here’s just the front bumper..

 

post a Pic after it’s reinstalled, what was the prep work?

 

Looked under the truck couple days ago and found a slow leak from the steering rack and a CV axle slinging grease. Just dropped $570 on a new steering rack from McGeorge.


I rebooted the axles about two years ago, not sure if I messed something up or if that's just how long I can expect from a reboot. Looking at the moderate angle CVJ axles, but it seems like it's my outer boot leaking and the axles from CVJ use OEM outer boots so I'm not sure if that would be less likely to leak.

 

1. Wash/Degrease
2. Sand it down 120 grit all the way
3. Wash again
4. Acetone to make sure I got everything
5. Raptor Liner Bed Liner Kit..compressor shooting around 50 PSI, hour between coats (2 coats)

 

Replaced valve cover gasket, spark plug tube seals, and exhaust manifold.

 

How much did they charge you to do the bead lock conversion? Looks great btw!

 

Finally got around to putting sound deadener on the passenger door. Put in new door lock while I was at it, on both driver's and passenger doors. Steering wheel cover done, the Wheelskins take a while but they certainly don't slide around, and summer is coming in Tucson. Also, switch panel is in.

 

I think it was 200 per wheel for the conversion, plus shipping. So maybe 1200 all told for a set of 5.

 

What? They're practically beadlocks for 12.5" wides

 

We never talk about stock FJ wheels but they look good on there. What PSI do you have to run fat tires at on those to get the center and sides to wear together

 

Bolted this junk to that junk and filled it oil

 

Dunno, 18psi? I think that's what I came up with for the Trepadors

 

X2 on these wheels.. I was hoping a set would pop up locally before pulling the trigger on my black rhino’s..

 

AllPro Baja bumpers and an integrated tire carrier from Coastal Offroad

 

All this cam tab gusset talk has me convinced to never help anyone put these on like I have a few locals asking me to. Besides the fact that I only have an inferior flux core welder, which oddly doesn't throw too much spatter, they look like a total PITA.

 

Do it once, just to say you did. It's a good excuse to drink and swear at things anyway