1st Gen Lunchtable Thread - General Discussion

That nut and bolt combo is doing most of the work

 

@Area51Runner I don't know if it'll help but I have a 98 j shift transfer case. However it's from a 4cyl so I don't know of the spline count matches up for you? I'd hate to part with it but I'd be willing to sell it if it'd work for you

 

Woah, welds with inspection holes! I bet @Kwikvette is an expert at those.

 

The first position is 2wd or AWD if you push the button

The second position is 4x4

The 3rd is neutral

The 4th is low range 4x4

 

Sweet! I hope he takes you up on your offer, I don't actually wanna sell mine

 

This is the correct way to use a reamer right?

 

FaBrIkAtOr

 

https://www.instagram.com/reel/CdYF3U0ligs/?igshid=YmMyMTA2M2Y=

 

looking at structural welds is always alarming haha

 

On the road and could use some help, can anyone tell me what the size/thread of bolts are that hold on a skid plate? I assume all four are the same but if not specifically the two rearmost. Thanks a bunch!

 

You can safely drive without the skid plate on if you need to head to a hardware store or the linke.

And yes they're the same. Pretty sure someone will be able to post the dimensions shortly but so far I know its M8 x 1.25.

Not sure on total length.

 

I fabricate you so hard holmes, you gunna wish you never been fabricated

 

Apparently 25mm long.

 

where'd you get this photo of my secret project

 

Where'd you get photos of my turbo setup?!?! Those are private and proprietary to Shitbox Constructs LLC

 

That Ranch Water got you sending weird texts late in the evening

 

Ahhhhh I see you're an engineering consult for shitbox constructs LLC as well

 

https://media.giphy.com/media/3o7Zesyac4CuSN5rsA/giphy.gif

"beware, the solid axle Dana 50 looks identical to the stronger and more desired Dana 60 axle and the internal components are not at all interchangeable"