blinker not working what should i do?

my passenger side front blinker wont blink and the back flashes super fast i changed the bulb in the front to a brand new one and it still wont work i checked all the fuses and none were blown the blinker housing is not getting any juice to it what could be my problem?

 

check the pigtail (plug) it self or wires going to it. or you could check for power going to the pigtail

 

i did and its not getting anything could i have a short somewhere or something?

 

do you have ground at least? your just gona have to start tracing down the wires.

 

could it be behind the dash somewhere?

 

Check blinker fluid level.

 

you should find and print yourself a wiring diagram for the turn signals. just trace the wire back because your rear blinkers working meaning everything should be fine but the wire going to the front blinker.

 

it done it when i installed my hids and it just stopped why does the rear blinker flash fast and the dash light flashes super fast why is it doing this?

 

thats usually a sign of one of the bulbs no working

 

are you sure you got the correct bulb for the one you changed?

that or take it out and re-insert it, may not be making a good contact.

 

yea i change it and took it out and put it back in like fifty times

 

I've had a similar problem once in the past on another vechicle. The problem turned out to be the bulb that was blinking faster than normal, it had a short in it. Try swapping the bulbs to the other side to eliminate them as the cause.

 

that or you may have to back tace your hid install

you may have somehow caused this new problem

 

great idea, elliminate all you can as causes

 

but my hids do not have anything to do with my blinkers the run on factory harness and different grounds and different power source

 

You mentioned it happened after you installed the hid.??

you may have lost a ground, pulled a wire, nicked a wire, etc.

the point being the blinker worked prior to hid, so something may have happened.

may have to get a multi-meter and check grounds and for voltage

 

just change it to a LED bulb like me

 

ROFL

 

Trade it in on a new truck.