What Have You Done To Your 3rd Gen Today?

Everything is going up except for the amount that people are getting paid. Bye middle class. From here on out you’re either rich or you’re poor.

 

is this normal?
I’m flying in Saturday morning to pick mine up and driving back

 

Is it a 4x4?

 

Yes and MT.

 

Built t harness for the radio, hopefully get all the wires ran tomorrow.

 

Update, with two mods I've shaved over 68lbs of weight from the truck. Swapping fridge set up and also swapping to the scs f5 wheels in 18x6. They claim those are only 18 2lbs each. So ditching the trd off road wheels will be nice. By my research that's shaving over 25lbs off of rotating mass.

 

Check out FBC Harness Solutions for a DRL tap for your specific headlights. Top quailty harness taps that are all plug-n-play, no cut, no splice. Made by @daveeasa.

Also if you move them down one row you can spread them out to every other opening.

 

Got all realigned, being in a shop is helpful when you're OCD about your alignment. Been lifted for around 1k miles, figured I'd clean it up after everything settled. Camber and caster held strong, picked up a little negative toe from settling, but set it back to 0.

 

Taking it to the dealer for the free 5k service. Please don’t scratch my wheels. Lol.

 

Good luck! Cheers.

 

Double check as much as you can before you leave the dealership.

 

Installed the GassHole this morning. Simple, but needed impact driver to loosen that Phillips machine screw. Could not budge it with normal screw driver, but instantly released with impact.

Man! Is that fuel door hinge bendy.

 

The R4T lights give 3 options for power: T tap, add a fuse and the DRL Harness. If I buy the FBC harness, which power option do I choose from R4T so that it plugs directly into the FBC harness? I'm assuming the DRL harness?

 

Crap! This place costs me money even when it’s not on Tacoma parts! I hadn’t seen this site. Down the rabbit hole we go…

 

Did you have to shave the housing to move them down one row? Every video I saw that had them on that row required shaving down the housing.

I don't mind doing it, I just didn't want to mess with it at the moment.

 

Nice. But you won’t need it.

 

Last few weeks I got a cmr, trimmed the fenders, and finally got 35s on two days ago!

 

I have my lights configured the same as Fatback17 and did not have to shave anything.
@Panchito V @Fatback17

 

Need to replace my needle bearings, but got to replace the rear wheel bearing on my wifes lexus rx instead. Amazing how well it all came apart considering its a 2005 with 165k miles and spent its whole life in MN.

 

man your truck looks great! I’ll keep an eye out on SD for ya