1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Transmission Pan torque?

Discussion in '3rd Gen. Tacomas (2016-2023)' started by PokerPilot, May 23, 2022.

  1. May 23, 2022 at 4:00 PM
    #1
    PokerPilot

    PokerPilot [OP] Well-Known Member

    Joined:
    May 3, 2022
    Member:
    #396405
    Messages:
    70
    Well, here it is 7 PM on the east coast and I have just drained my transmission and pulled the pan to clean it out and install a new gasket. My problem is I don't have the torque values for the pan bolts. If anyone has an idea I would be grateful so I can button this up soon. Thanks!
     
  2. May 23, 2022 at 4:03 PM
    #2
    Bishop84

    Bishop84 Well-Known Member

    Joined:
    Dec 17, 2015
    Member:
    #172494
    Messages:
    11,948
    Gender:
    Male
    They are aluminum and I recommend no torqueing, just gentle hand tightening, warm it up, then check all the bolts.

    It's 65 inch pounds. Very low.
     
  3. May 23, 2022 at 4:36 PM
    #3
    PokerPilot

    PokerPilot [OP] Well-Known Member

    Joined:
    May 3, 2022
    Member:
    #396405
    Messages:
    70
    Thank you. I noticed they were fairly easy to take off with just a short grip and a twist of the wrist.
     

Products Discussed in

To Top