1st Gen Lunchtable Thread - General Discussion

I'll pay you for sliders, 80" same as a second gen

 

GOTTA LEAVE ROOM IN GEORGE'S TRAILER FOR THAT SIDE BY SIDE BARBARA LOVES SO MUCH CRANK ON BROTHR AROOOOOOOOO

 

I just need to make myself some and you can come grab these

Every time I say I'm going to pull off my rear bumper it's either - too hot out or too late so I'll do it tomorrow

 

Taco needs em not the LC haha. But I won't say no to the LC door ding resistors too

 

Relentless fab still has one in their website somewhere around $2500 sitting in the shopping cart.
Coastal Offroad has one I like too. I feel like after factoring in powder coating the cost between the two isn't far off.
Aluminum would be cool

 

DIY kit and spray paint will save you a lot of money

 

I still really like the 4x Innovations rear

 

DIY turns in to gee I cry half the time. My back isn't what it should be

 

HELL YEAH HE GUST GOT THEOSE LED WHIP ANNTENNAS AND A NEW BLUETOOTH INNIT TOO

 

before every diy project: this will be EZ, i'vve done worse

during: damn it, I should have known better

after: haha that really wasn't that bad was it

https://media.giphy.com/media/f74WDV59cP0NArh8gu/giphy.gif

 

You're telling me

I use a theracane every day

 

Going to a metal shop tomorrow after school to maybe get some material.

Thinking I'll go rectangular tubing for the swingout so I don't have to go so thick and heavy versus square.

 

I like the looks of the plate steel. Round tubing just doesn't do it for me

 

I find that making a spreadsheet with weights and prices really helps my decision making. Even if it’s just a ballpark, I can save a lot of weight and money by figuring some round numbers beforehand

 

I really like their stuff, and they still keep it cheaper than most others.

 

Here's the idea -

Flat plate that becomes the "face" of the rear bumper. This will bolt onto the rear bumper as it's part of the frame.

The ends will extend out for a swingout, only one and it'll only take half the width not the full width of the bumper.

Once that's done, it just comes down to welding plates for 'brackets' so I can make it a bolt-on piece.

But yeah you're right in that I should find out the weight of desired tubing. Just figured with rectangular tubing, I have a larger surface area to weld with and on so I wouldn't have to go so thick on the material.

 

I AM TRUZTING YU GUYZ TO NOT C0PY MY DESIGN AS ITZ REGISTRD TRADE MARK BY KWIK FAB KTHX GUYZ

I TRYED RELLY HARD ON IT

 

I really like the Relentless rear wrap around bumper. So expensive though. Especially with the swingout.

 

Guys whenever replacing the ac clutch should I removed the whole compressor?

 

Big Texan Challenge!
72oz (4.5lb) steak, 3 fried shrimp, 1 dinner roll, 1 baked potato, 1 dinner salad ---- 1 hour time limit.

source: https://www.tacomaworld.com/threads/big-texan-72oz-steak-challenge-live-cam-and-commentary.688770/

Honestly though, forget the challenge... just watch the live vid feed! Will they

https://v.angelcam.com/iframe?v=9klzdgn2y4&autoplay=1