What Have You Done To Your 3rd Gen Today?

They are DS18 pro. Plug and play form on JBL. Here you go- and right now 10% off. The are on Amazon as well but last I looked full price. https://ds18.com/products/pro-1-9-o...d-subaru-models-120-watts-1-aluminum-4-ohm-vc

 

While technically not done today (should be installing tomorrow)
This came in the mail Friday!

 

A preview of what it will look like.

 

I have a low deductible for windshield replacement. $50 out of pocket. Insurance paid the rest.

 

Finished up the anytime backup and front camera. Mounting bracket came from the Taco Garage. It certainly is a spaghetti mess of wires at first, rather intimidating. But the directions are easy to follow, with plenty of pictures. Only thing I needed youtube for was taking panels and stuff apart. One thing I didn't care for is they suggest tying in the grounds to the side of the radio bracket, which is not actually grounded when the HU is pulled out.

I would say the image quality of the 'premium' camera is slightly lower than the factory reverse camera. But it will certainly get the job done.

 

Added the front VLeds footwell lights. (I'll be doing the backs later this week).
FYI...They are having a 15% off Memorial Day sale right now.
Nice kit...I'll probably like them even more in the dark!

 

Took a while but finally got to 9000 mi.

 

$1300 let the insurance company pay for it, have the dealership do it right and replace it with Toyota glass, not the safelite beach sand special.

 

Oh, nice. I am going to get this same bumper (same configuration) and wondered if I could just zip tie the license plate like that. Were you going to leave it like that or is it temporary?

 

Got the KDmax pro +xt tune this morning. So much better

 

Holy shit! I have to have this, for my office at work. Wheeeeeeeeeeeeere did you get it? Tell me now!

 

Full CBI skid plates installed. Have gas tank skid on order.

 

That was temp. Now have it mounted in front of fairlead.

 

Pulled off a front runner roof rack, revolver x4 tonneau, rci bed rack, and my rtt.

Then installed the front bed rail and total chaos bed stiffeners.

Before:

After:

 

Oil change
Anti sway bar removed
Quicksand skid plate letters.
Cleaned cabin filter
Cleaned motor K&N filter
54k miles.

 

Put it to work doing landscaping this weekend. I finished the mulching and came in to order a 2Lo kit. The reverse gear is way to tall for a truck! You should not have to use 4Lo to back a trailer around the yard to keep from smoking the clutch. Thanks @lapoltba for the harness.

 

Aux relay panel.
Switch panel.
Talons Garage skid plate/cat protection

Not visible is a bunch of wiring and an air compressor. Been done over the last week.

 

Which Billstein’s and coils are you running? How’s the ride without the anti sway bar? TIA! Truck looks awesome BTW!

 

I have the 6112bills on 3\4 knotch with the 5160 rear.
You can tell the sway bar is off. It rides way better/smoother. I will not be putting it back on.
It was super easy to remove

 

Oh fancy! I like your taste in cement grey.

I'm stoked to get mine so I can finally drive out on these tires... although, it gives me a chance to take the new coilovers out, compress them, and adjust the ride height. I didn't have a nice spring compressor, so I found a nearby ATV shop that will let me use their floor mounted one for free.
C4 says ~14 week lead time, plus what ever shipping and clearing customs takes.