What have you done to your Tacoma today? 1st Gen Edition

It just looks better black - i feel ya, had to do the same with mine

 

Same. I’m actually a fan of the stock front and rear bumper. Just not of chrome.

 

Hopefully your wait is almost over. The Panamera shrouds look sweet. Bit of a tight fit, but we got it. You'll love them though.

 

I'll take em.

 

Got bored today and decided I didn’t like the peeling silver plastic caps on the wheels anymore. Dipped them black, thoughts?

they’ll be getting swapped out eventually for some 17”s, just wanted to see what black would look like.

Also swapped my shifter knob.

 

I dig it.

 

I cleaned 18 years of crud out of the AC fan. Was going to tackle the evap coil but it’s to doggone hot this afternoon.

 

What was your approach for cleaning those fan blades? It looks brand new

 

Sold. PM me.

 

3 iterations of this stuff followed by a careful rinse with the garden hose.

https://www.homedepot.com/p/AC-Safe-Air-Conditioner-Foaming-Coil-Cleaner-AC-921/206740351

 

Imma have to give that a go on mine. Last time I pulled it out it was pretty caked on there.

 

Adjusted the height on my Fox 2.0’s

 

What seats are these?

 

changed the oil
....now to load it up with guns and firewood for a Memorial Day ATF campfire out east!!

 

Well @betterbuckleup was over and pointed out that I was missing a rear bump stop looks like the baseplate just broke off.

ran down and grabbed a Chevy bump and made a quick fix before headed out for a wheeling trip tomorrow.

 

Finally installed Heavier rear springs has 6 leafs now instead 4. Had bought add a leaf from OME didn’t care for its looks. Got coupleheavy ones off my neighbor Older GMC one ton panel van. Had cut bit length off but install went well. Wow what a difference. Taco rides so SO much smoother now, before could run over dime in road & feel it. Rides more like a car than 4x4 now. I’d installed Old Man Emu off road Nitro chargers few months ago now they can function properly.Total lift now little over 2 1/2 “. Running 32 rubber on 17 wheels. Tons clearance. Bet33s wouldn’t even rub but sticking with what got for awhile. ⭐️

 

Here’s pic them

 

Swapped my shifter handles for dark gray 4Runner ones

 

Transfer Case Input Shaft ID... from a 4cyl or a 6cyl??

 

I don't think the answer is there yet, but @turbodb put together a transfer case ID guide you might be able to add to as you figure things out: https://www.tacomaworld.com/threads/1st-gen-transfer-case-identifcation-for-replacement-swap.753707/