1st Gen Lunchtable Thread - General Discussion

Free metal is the absolute best when you're fabricating...


Unless it's fencing material, we got a bunch free from a vendor that built fences as a side job and this end molding and fancy railing sections are freaking useless for anything other than fences lol

 

you can make something like this with all that fancy metal

 

If i had to guess it was a couple months later when I rehashed things again for someone who had been out of the loop

 

I know I came late to the party and you had to rehash axle roommate drama to me cause I asked.... you guys can blame me for the missing meme gold

 

.

 

Needs poverty-pixelated Pikachu

 

How many hours of company time did you waste trying to find that post

 

about 4 minutes of a well earned break

 

Guess we know what you did for the last minute of your 5 minute break

 

1 minutes is a long time

 

You magician you

damn it's not as cool as I remember it being lol

 

@Sperrunner Now that you have the small Lego plants....next up for your yard

 

If I weld someone's bumper for them at my place, at my leisure, does $175 sound right?

Its a Coastal Offroad DIY kit.

 

How long do you think it will take overall? Id say about $50 to $65 per hour time how long it will take.

 

It took the Land Cruiser bumper about 2 hours total if I include having hit the front with a flap disk.

He's looking at a full kit so add wings and I'm thinking about 3 1/2hours if I'm also cleaning welds.

 

are you cleaning it up, fitting it, tacking, and finish welding? or just finish welding?

 

It's a kit so it'll require minimal fitting.

Will get it tacked up at my place on his vehicle and then we'll pull it off so I can weld it together and clean up exterior welds.

 

In before someone says I should pay him since I'm the one welding it

 

$300 sounds reasonable.