What Have You Done To Your 3rd Gen Today?

I always find stuff here I didn't realize I needed. My seat is adjust full up in front, full down in back.

I imagine it feels better, but is it very noticable?

 

I just pulled the trigger on a soft topper. I currently have a cbi bed rack which is great, but I really need to be able to cover stuff in the bed. My two Australian shepherds take up the whole backseat. I'm trying to decide what what bed rack to replace my CBI with.

 

Oil change on the 2.7L manual

 

Did the plate/ interior LED upgrade that’s much brighter than OEM, but not too bright. It’s the little things.

 

You should notice it right away behind the knees with the extra support. The problem most of us have with the taco is the seat support seems to drop off or disappear around mid thigh. That's at least the difference I noticed between stock and risers.

 

So far so good, my rims are FSW's version of the 2021 4Runner PRO rims with the 0 offset. No rubbing under normal driving conditions that I can hear or see and I live on a crappy dirt road.

 

Are those 5100s or 6112s, and what spring compressors are you using if they are 6112s?

 

Yup! Always finding stuff maybe I don’t really need.

So there were so many positive things said about the jackers that I kept it top of mind. And I’ve had lower back soreness for years and people swore by the product.

Installed it this morning and immediately noticed two things: it felt like I sat a bit higher and it felt like I had more leg room. I know this was true because I used the electric controls to readjust my seat.

I don’t think the added height is noticeable but I did have to stretch a little bit more to get in. It wasn’t an issue though getting in.

I honestly feel like I’m going to enjoy driving even more now that my seat is in a lumbar position.

 

I was able to fit 285s with my TRD Lift with no rubbing! Looks great either way

 

They are the 6112s, you can buy them pre-assembled already too. I got mine from shocksurplus

 

Installed the anytime front facing camera. This kit also includes a reverse camera override so I can view both front and rear cameras in any gear at any time

 

Are you in Seaside?

 

Oh no not good. I just installed them today with some 5100's on my wife's rig.

 

Awesome!

bushings are in the mail. So probably another week until I can install them.

 

I finally had time to install At the Helm bed stiffeners.

 

Nice. Wasn't a bad install. My shocks were rusted had to cut the top off with my angle grinder but other that that was really easy install. My rear end is about 40" from the ground to the bottom of the fender. Should settle out eventually though.

 

I have an Icon AAL 1.5” on the stock leafs but it’s sagged. It’s about 38” with 285/75r16.

I want to get back around 40”. So I can raise the front end another 1.5” higher.

 

Great, I have 6112s but need to swap to 650lb springs. Can you tell me what spring compressor tool you are using in the photo and how well it worked? I may have to adjust the clips and I don’t want to have to go back and forth to a shop, or pay $100 to make the spring swap and another $100 if I need to adjust the clips.

 

Looks great!! Nice placement of the camara.

 

thanks! I didn't measure it at all before I drilled a hole. I got really really really lucky