What have you done to your Tacoma today? 1st Gen Edition

I've been there brother. Only it was the starter that was the culprit at the Costco gas station. No push starting with the auto.

 

Swapped out rear diff oil, tightened up the bolts on the 3rd member (it has been dripping slightly, 2 of the bolts had room to tighten), diff breather extension mod, and installed the carrier bearing drop that I've put off since my lift. I noticed two things in all this: my carrier bearing is shot and I noticed a potentially loose bolt near my handbrake line/BPV when looking over my pictures after the fact.

 

Why am I hearing someone play a tambourine when I hit bumps lol.

 

She's lookin pretty clean



Took apart the blower motor and vacuumed out the ducts. Cleaned out the condensation outlet. Seemed like it was backed up.

Think I need to get the A/C charged too.

Didn't really get shit else accomplished this weekend. This heat really fucked my plans.

 

got the bed off the wrecked on. also. got some pics of the interior... shes rough! lol but the measurements i took of the rear of the frame, it appears to be straight. so clean up and as long as the front end is solid, the 98 will have a frame.

 

beer cans in the bed?

 

I wish. That’ll be on the 3rd though

 

I dig the 5 spoke wheels

 

Pro Comp Predators.

I had those in my cart for 2 damn years vefore I finally bought them.

 

Do you have coillovers? Could be the bearings. That what mine usually is when it make that noise.

 

Ya I got the full OME setup front and back but they’re still relatively new I think. Installed everything fall of 2020.

 

Rubber bushing, not bearings then.

 

Anyone running the BAMF LCA skids?

@Kwikvette going the Land Cruiser style, I ended up with a set. I'll probably install this weekend. But I'm kind of apprehensive about boring a hole in the structure of that little leg that the LBJ stud passes through and bolts to.

Has anyone had any problems with that?

 

I personally don't see the point in them. I have not heard of anyone damaging a LCA on a rock yet. Unnecessary weight and lower ground clearance.

 

Ya, I see that side too. Like you, I've never seen anyone have a problem those skids would have avoided.

I would, likely not even consider them but. I'm planning on replacing my LCA bushings, re-enforcing my cam tabs, and installing the alignment cam eliminators this weekend. I'll already have the LCAs off, so drilling them will be at the easiest point they will ever be right now.

Again, haven't seen where anyone has "needed' them, but I'll be on Slick Rock in a couple weeks and Rubicon in August. A little extra bash protection can't really hurt.



Besides... they were free... and since I'm one of those "cheap assed 1st Genner that doesn't spend money on their trucks", I thought it would be fun to wear them kind of like a scalp.

 

Both times through the rubicon I maybe got one new scrape. I would avoid the extra weight.

 

I don’t think it really matters, his truck is already chuuunky

 

That’s why is matters the most . Keep the weight down where he can

 

FIFY

 

If you like em thicc

I’m more into lean