What Have You Done To Your 3rd Gen Today?

It drips down onto the frame.

https://www.tacomaworld.com/threads/rust-on-frame-with-a-c-drain-mod-fix.444138/

 

Just imagine how much more you’ll spend on a bigger truck!

 

I like the way they look. Might be a pain to clean well see.
I did have to take the wheel off, so i did a tire rotation while i was at it.

 

The instructions said to carve out just the red sections in the picture not the entire portion behind the bracket, but yeah I thought the same. Basically, if you utilize the top switch blank you'll need to cut out behind it so the switch has room. The bracket itself has tabs to hold it in place though. I opted not to carve out anything in case I want to return to stock.

 

Made a run to the dump. Other than that, Just a wash and loading up the kayak for tomorrow.

https://ibb.co/bJcJGmk
https://ibb.co/VCH1Gtd

 

I want to be you when I grow up.

 

TRD Coin Cup

 

Finally installed the CaliRaised Hidden Lightbar. was a bit of a pain to install but turned out good.

 

Bought the 3 ton Pro Eagle Jack and did the wheel swap myself

It's an overkill for stock height Tacoma, I didn't even need to use the extension. Just straight up jacking up from the frame on the side and both the front and rear wheels are off the ground.

 

Where’d you get that?

 

LCA skids, Baja fogs, and custom brake line drops on the menu today

 

Not sure where this person got that one, but I just ordered this one.
https://www.tacomalifestyle.com/products/tacoma-coin-tray-bucket

 

Yikes!! wish it were cheaper. $30 is a bit much for a coin holder.

 

I found a 3D printable one on thingiverse, but it didn't turn out very good. Perhaps because I don't have an expensive 3D printer, or I don't know how to use it properly. I like the way this one looks. But, yeah, a little pricey for what it is I guess.

 

That area on my truck is used to hold a small bottle of Bath and Body Works Warm Vanilla Sugar Hand Sanitizer and the plastic screw-on cap when I remove the HAM antenna for the car wash.

 

Here ya go.

https://www.ebay.com/itm/3250126968...Qk6jxA3QTG&var=&widget_ver=artemis&media=COPY

 

I got this one on Etsy

 

Thanks to good guy @Speed Freek,
I installed my Hellwig rear sway bars to mitigate the body roll some .
*(after it sat home in the box for nearly a year)


Rear sway bar is set to medium firm.
I'm going to set it to very firm.

Also replaced my sparkplugs (20k miles late).
Old plugs looked decent to my big surprise.
I replaced with original OE Denso (FK20HBR8).

 

Continuing my topo wrap from my tailgate upward onto my rear door on my knock off alucab project off

 

if I would have used my brothers Ram with the Cummins diesel, it would have def been less gallons and better MPG, but diesel is about $1.20 more per gallon. So around the same cost in the end