What Have You Done To Your 3rd Gen Today?

How do you like the Ironman leaf springs? Also what hangers are those?

 

how's your suspension, I see you have the arb bp-51 any good?

 

I just got the BP-51’s with the Ironman leaf springs and Archive Garage Hammer Hangers. So far I like them. They are nice and quiet (right now) too.

 

Looks really nice! I just did the Headstrong AAL and left the overload leaf in. (I'm running about 400lbs of gear when fully loaded for a week plus trip)
Truck looks a little absurd with no weight in it TBH. The ride is also a bit harsher than I'd like.
Probably going to end up doing something similar to yours a full leaf swap.

 

One of the best most practical “mods” I’ve done to my truck. You’ll really enjoy it. No matter the temp outside, I can grab the steering wheel without it being too hot.

 

Street cred (off-road cred is more accurate) looks awesome! Don’t fix the scratch on the skid! Haha

 

Anyone wondering if you can fit a ripp oil catch can with an OGE dual battery system and a group 35 battery. Just barely.

 

J&L PNP oil catch can & tailgatecamera PNP camera relocation kit. Wanted to get ahead of oil everywhere in the intake as my supercharger is about to ship soon. Also camera comes with a new camera and 2 mounting brackets. Had to do this cause my CBI high clearance bumper was in the way of my OEM camera. It was easier this way then rewiring and moving mine.

 

Those are some fancy taillights. Do they require any extra connections?

 

That relocate is so clean! I'm gong to have to add this to my mod list!

 

Nope. Plug and play. 3-5 minute install and that’s taking your time.

 

Ad a box from @hot

Lowlander!
Where did you get it done? I’m thinking of doing the same.

 

Replaced driver’s taillight after the youngest borrowed the truck for vacation

Next up, bumper cap and BSM sensor

 

Added some demon brackets and red D ring shackles for $100 good deal !!

 

Put a Cali Raised LED front bumper on.

 

Those side stripes!!

 

That sensor and light need to be replaced, but the bumper cap can be repainted. Some wet sanding, paint and buffing and it'll look fine. I did the same to my quarter panel and bumper cap

 

Are those the tails that came with your truck (2018 TRDOR DCSB) or did you replace them with another year or trim level?

 

removal of visor stickers:
heated the visor up with a small space heater, or
can use an iron by covering sticker with clean old tshirt
worked a corner up -fingernail-enough to start peeling slowly,
after sticker gone glue residue left so,

put a clean piece of t shirt over spot and ironed it for 15 - 20 seconds,
one sticker had more glue so re ironed with clean piece of shirt a couple more times till it looked good,

 

Color Graphics Colorado down in Windsor CO, went based upon recommendation from a coworker. The owner is originally from Wyoming.