What Have You Done To Your 2nd Gen Tacoma Today?

As I've said before I don't get to post here too often due to my CFO. Thanks to Keith at Charvonia Design @602runner. He had a "contest" a few weeks ago and I received a set of his tie downs for free.

Also during Amazon Prime day I picked up a set of Husky floorliners for 50% off.

 

I’d help if you lived closer! Lol

 

Cleaned the engine bay this morning.

 

Today I replaced the junk spc upper arms with jd fab uppers, installed a mrbp cat back exhuast and oil change and greased everything.

 

Can you please give honest opinion about exhaust? Does it sound shitty?

 

I rarely drive during the night but what I can tell from when its a little darker when its gloomy out or earlier in the morning its pretty bright

 

You gonna sell your OEM headlights?

 

I dont plan on it If the headlights ever go out on the alpharex then I'll have the OEM to go back to

 

Just a funky flattening angle.

It's exactly as it's supposed to be like the other side, those hoses while "flexible" to a point there's no hope in heck I could kink one by hand, they're quite tough.




Good looking out though!

 

gots the new good good , wireless carplay!

 

Made a little more room for larger tires. Still need a cmc or relocation. I have 3”/1.5” lift still deciding on tire size 285/70-17,295/70-17 or 315/70-17. This is my first lifted Tacoma.

 

A while back I had a very good friend mill some ramps based off my hacksaw prototype to replace the very ineffective original ramps for the swing out gates on my rear bumper.




The Originals that had a wrong angle and didn't do much to guide or support the gate at the catch and they tended to rattle a bit, plus with how they were attached with a countersunk screw and didn't go all the way to the back plate they weren't very sturdy oo adjustable at all.

My rough prototype largely fixed the issues stuck down with 3M tape but only supported the gate wedge partially due to the blade walking and the face being uneven. UHMW likes to be milled it doesn't not like to be abraded or slow cut hence the hacky looking middle prototype.



As it turns out milling a wedge is a bit of a challenge but he got them done beautifully and I got them installed today.

 

Did you Line-X your truck?

 

Raptor liner

 

Go big. Lol 315-70-17 all the way with some new rims

 

Wired up the power mirrors for my base model regular cab.
Also doing heated but waiting on spade connectors.

 

Already have a new set of scs wheels setting in garage 17x8.5 -10

 

Did you have it done or do it yourself?

Looks great either way, if you did it yourself; how?

 

Did it myself it’s about 2 yrs clear coat was coming off so this was the most cost effective solution. It’s a pretty straight forward system. Sand everything, mix (liner,hardener and paint) and spray ( It has its own gun).

 

How much that coat you and how long it take?

I've really been wanting to Line-X or Raptor mine in black.