What have you done to your Tacoma today? 1st Gen Edition

checked how tight all lug nuts were and u-bolts. ready for the trails this weekend!

 

Yea if I knew what I know now, I would have probably just got the 170 strikers, which are 7" I think. But I just went outside and adjusted these and they are stupid bright.

 

installed N-Fab Step Bars!

 

I washed my truck, in prep for tomorrow's SAW 2.0 rebuild (remove, rebuild, recharge and reinstall), skid plate re-install, replacement of the HVAC controls and rear o2 sensor - posting now as I'll be busy most of the day

 

bumped my trailer this morning in a rush to get to school. thank god i have a huge bumper. saved my front right panel. best mod if you ask me. saved me a few $$$





i know it sounds like im a shitty driver but im not. just happens to every one at some time.

 

what did you do with the hvac controls? I'm confused.

I washed mine today

 

Is your bumper done or you still working on it?

 

still working on it.
borrowing my father in law's wire feed welder to weld some tabs on, that I will bolt the plate to.

then I just have to wait until I can afford some plate and getting some design cut into it. (can't do shit without a job)

 

Oh i hear ya man! That thing will be sweet once its done, you need some recovery points.

Good luck finding a job man!

 

thanks!

yea I was going to do the receiver hitch, but might just do some recovery D rings instead

 

Threw some 255/85s on last night, super happy, now all I need are some gears and lockers. 4.88s here I come

 

I put on some eibach coils and diff drop like a week ago then I got my new LR UCAs installed two days ago and got an alignment and installed the URD short shifter and washed out my interior yesterday and once I get some time I'm gunna make a satoshi grill and paint the surround black and order me some black headlights... yay

 

I took my rear door panel off to see why it won't open from the inside anymore.

 

This thread is now a sticky. Thanks Bob

 

Did the "axle wrap mod" using leaf spring helpers, and completely disassembled the rear interior (down to the last layer of sheetmetal) to get to a dent low on the body just behind the passenger-side door. Got the dent 95% out, which is MUCH better than it was...

I found it interesting that when I took the floor-mounted seatbelt anchor bolts out I could see daylight!

 

thanks jerry

 

Wooo my first sticky

 

Installed rear 10" bilstein shocks from downtown motorsport and holy shit, rides sooo much better. im soo happy with how it turned out. will flex pretty damn good now.

 

rear diff breather extension cleaned MAF. and adjusted throttle and detent cables

 

Like the wheels, dude! Where they from??