What Have You Done To Your 3rd Gen Today?

One of the first things I did. It was like getting new seats. You made a wise choice

 

After noticing how much heat the R4T exhaust was dumping on the wire for the ABS speed sensor, I decided to wrap it with some DEI heat wrap before it got melted. I’m pretty sure its routed this way, rather than behind the axle because of the rear disk brake conversion.

 

Thank you for your feedback!

 

Installed Desertdoesit seat jackers in the front last night. Not sure yet how I feel about them. Definitely feel like in sitting up higher

 

Is there a conversion kit from drums to disks?

 

of course

 

Completed the install of my CaliRaised Premium roof rack Saturday after starting Friday night. Couple notes so far, the hardware bags has some bolts and washers mixed up but they were all there so no issues; double check all the bags before starting install is my opinion. The next issue and this is a major one, the install called for 3/8-16 coarse nylon nuts over 3/8 bolts. However, the hardware bag contained 5/16-18 coarse nylon nuts. I had to head over to Home Depot to pick replacements. This caused the install to go longer than intended. Other than that I like it.

Today I’m going to create the wiring harness for the premium 360 lighting and get that all installed. Will post photos soon.

 

https://sosperformance.com/t/rear-disc-conversion-tacoma

 

best way to get a true measurement is to get it from the center of wheel hub to the fender flare edge.

 

Got the bump stops on. It's only 4,000 degrees so super easy install. I'll have the video up this week as long as I can replenish my fluids here soon with out passing out.

 

Seems like you might want to do something about the center pin on the leaf pack, to distribute the contact, should it hit. a plate over, or grind it down a bit, maybe?

 

Haha, but you will eventually.

 

Loaded up the ATV and cleared trail at the hunting club.

 

Wash n Wax

 

Where did you get those center caps?

 

Part #: PT280-35170-02

I ordered them through a dealer online.

 

Here I am, jumping online to pass an order for a set, haha!

 

where’d you get the metal ramps?

I don’t trust the plastic ones.

 

Also interested in the link for the metal ramps, for the same reason!