Keystone State Thread

Rob, anywhere near Pittsburgh? I just put one in my mother's house. We'll I helped and my buddy did it. But the supply house have plenty.

 

other side of the state Allentown
I work for a builder free install just need to pay for the unit at there discount.

 

Oh your set then. Good luck however I think u might have some hot weather next week. Start making ice lol.

 

Thankfully I have a finished basement with a portable ac unit.

 

Now that I can like !

 

Welp that was a long day. Just walked in the house 5 mins ago. Was gonna go out to a little event that's going on. But now that I'm home I'm not going anywhere. Tomorrow I'm doing brakes and a oil change on the work truck. No worries all I get paid cash doing all the work on my work truck. Anywho hope everyone had a good day.

 

About a month late to the party....

Where exactly in SE PA? Two places come to mind:

Schaeffer's Auto Refinishing in Schwenksville, PA
AAC Offroad in New Tripoli, PA

I've had work done at both places.. Outstanding people.

 

Good morning fellow Pennsyltuckyvanians!!!

 

Good morning. Wife's family reunion is today. She wants to stay for hours and hours. I like to make an appearance, make some conversation then go after a few.

 

Good morning my neighbors from across the river. Was woken up by a slap on the face by my shep. His paws feel like sand paper

 

Sitting at home in my undies drinking tea fixing active directory.

 

Hey all, I just finished a 6500 mile, 27 day trip to SD, MT, UT and CO, living out of my truck in national forests. I stopped at the Flight 93 Memorial on the way home to ChesCo, which I have been wanting to see for a while. Think I spent 2 hours there. I would definitely recommend stopping in if you haven't seen it, and it's free to get in.

 

Nice. That's on my bucket list. When u can share some pics.

 

Hey y’all, I know this has been debated and stated for ages…. But 265/75r16 will fit my stock 21’ SR?

 

Flight to San Francisco went fine, but getting a rental car is another story...

 

Anything is possible with a grinder, cutoff wheel and a CMC. I have a couple sets of cmc plates and do them for $200. I've done atleast two dozen CMC's on 2nd, 3rd gen Tacoma's, a couple 5th gen 4Runner's and a 2020 Tundra. I always cut and place the cmc plate as far back as possible to easily clear 35's with a 2-3" lift.

 

Good afternoon. For those in the greater Philly area, don't forget about the Hatboro Car Show this afternoon/tonight. It's usually a great show.

 

Yes they (should) fit with no trimming or lift required.

 

Good morning fellow Pennsyltuckyvanians!! Hot Air Balloon flight scheduled for this AM - really cooled off last night, down to 53 here.

 

Morning Pennsylvania