What Have You Done To Your 3rd Gen Today?

Thanks for the feedback. The drone is exactly what I'm trying to avoid.

 

Looks Great! Glad the video helped. I didn't even read the directions because I watched the video several times.

 

You can set it up 1 of 3 ways. I opted for “moderate tone”. The NDT chamber has their “No Drone Technology”.



This is how that actually looks.

 

Would 100% buy some when you have them done.......

Always available to test them too......

 

Which roof rack do you have?

 

I have an UpTop Alpha, and I’m also a fan of your anchors. In fact, I almost ordered some bed rail tie down anchors before I checked my previous emails from you and saw that I already have them.

 

wrap the lock in duct tape to keep crud out.

 

RCI

 

Reminds me of when in my youth I had a 1970 383 Road Runner with cherry bomb mufflers. Man after 2 years of that noise I had to let it go.

 

First post here, I've been enjoying this place for quite a while though. Today I had some new wheels and tires installed, I'm quite happy with how it turned out! Blackhorn Offroad BH01's wrapped in Falken Wildpeak AT3W's in 265/70/17. Sits just right for my tastes.

 

Finally mounted the FSW wheels and KO2s today.

 

Is this the Magnetic Grey Metallic color? Looks very fine!

 

Yup, that's the one. MGM for the win!

 

anybody found some hooks that would screw in there?

 

the one they put in may be installed wrong

 

the spare comes with a way to lock it

 

Picked up one of these bad boys…

 

Do you have a lift ? What size tires are they

 

New shoes (275 70 17 KO2s) and wheels to match the trailer (Vison Manx 2 17x9 6-139 70 12 BKMTXX). +12mm backspacing is exactly the stance I was looking for.

Zero rub, no CMC, no trimming. When I installed the OME-005 Heavy Kit and the SPC UCAs I had the alignment shop go as far out as they could on LCA caster before they messed with the UCA to get me 4.0 deg caster. I am eager to stuff them to see where I'll need to trim or mold the plastic.